Abstract:The dredging sludge from river channels is a challenging task due to its low strength and high compressibility, and the use of magnesium oxychloride cement (MOC) for curing treatment has a high sustainability value. In this regard, the synergistic solidification efficiency of magnesium oxychloride cement (MOC), along with the selected additives (e.g., sodium silicate, CFBC desulfurization ash, and silica fume), on tested sludge was systematically evaluated by the Unconfined Compressive Strength (UCS) and microstructural tests. Initially, the baseline component ratio of MOC solidified sludge was determined through analyzing the effect of the water content, MOC cement dosage and molar ratio of MgO/MgCl 2 on its solidification strength. Subsequently, a suitable dosage range for each additive was obtained by observing the UCS's growth behavior for MOC solidified sludge containing a single additive. Then, the regression model for predicting the UCS was formulated using the Response Surface Methodology (RSM), and by interrogating it, can optimize additive contents in terms of the UCS requirements. To collect the experiential data, twenty mix designs with different sodium silicate contents ( x 1 : [4%, 8%]), silica fume contents ( x 2 : [2%, 6%]) and CFBC desulfurization ash contents ( x 3 : [2%, 6%]) were generated by Central Composite Design (CCD). Finally, the phase composition and microstructure differences of composite MOC solidified sludge, MOC solidified sludge and undisturbed sludge were compared to reveal the solidification mechanism of composite MOC cement on tested sludges. The results shows that a specific component mixing ratio (MOC cement: sodium silicate: silica fume: CFBC desulfurization ash) of composite MOC cement for satisfying maximum solidification strength is 10: 5.35: 5.34: 3.45. The strength performance of composite MOC solidified sludge is superior to that of MOC solidified sludge, as evidenced by the presence of numerous flocculent hydrated products such as phase 5(5[Mg(OH) 2 ]·MgCl 2 ·8(H 2 O)), M-S-H and C-S-H gels in composite MOC solidified sludge, while only short rod-like phase 5 being detected in MOC solidified sludge. Herein, a conceptual model on the sludge solidification using composite MOC cement was also innovatively developed.

MECHANICAL PROPERTIES AND MICROSCOPIC MECHANISM OF PAPER MILL SLUDGE-MAGNESIUM OXYCHLORIDE CEMENT COMPOSITES

Mechanical Behavior, Durability, Thermal Performances And Microstructure Of Ggbfs - Modified Mpc Solidified Dredged Sludge

Study on Physical and Chemical Properties of High Magnesium Nickel Slag-Phosphogysum Composite Cementitious Materials in Different Particle Sizes

Study on the Basic Properties and Mechanism of Waste Sludge Solidified by Magnesium Phosphate Cement Containing Different Active Magnesium Oxide

Mechanical properties and chemical microscopic characteristics of all-solid-waste composite cementitious materials prepared from phosphogypsum and granulated blast furnace slag

Development of composite magnesium oxychloride cement and its application on solidification of dredged sludge

High-value utilization of modified magnesium slag solid waste and its application as a low-carbon cement admixture

Investigation on rapid solidification of waste dredged sludge with magnesium phosphate cement modified by GGBFS

Cementation Characteristics and Hydration Mechanism of Magnesium Slag-Phosphogypsum Composite Cementitious Materials

Experimental investigation of dynamic mechanical properties of foamed magnesium oxysulfate cementitious material

Preparation and Study of Magnesium Ammonium Phosphate Cement from Waste Lithium Slag

Modification of Magnesium Phosphate Cement with Steel Slag Powder and Ground Blast Furnace Slag: Mechanism of Hydration and Electrical Conductivity

Effect of Fineness on Mechanical Properties of Cementitious Material Made from Magnesia Slag

Hydration Characteristics and Mechanic Properties of Basic Magnesium Sulfate Cement Containing Steel Slag

Design and Preparation Technology of Green Multiple Solid Waste Cementitious Materials

Microstructure and Key Properties of Phosphogypsum-Red Mud-Slag Composite Cementitious Materials

Mechanical grinding activation of modified magnesium slag and its use as backfilling cementitious material

Mechanical Properties and Microscopic Mechanism of a Multi-Cementitious System Comprising Cement, Fly Ash, and Steel Slag Powder

Study on the Effect of Ash-Slag Ratio on Mechanical Properties of Magnesium Slag Cementitious Material

Utilization of waste marine dredged clay in preparing controlled low strength materials with polycarboxylate superplasticizer and ground granulated blast furnace slag