Abstract:Breathing motion is one of the major limiting factors for reducing dose and irradiation of normal tissue for conventional conformal radiotherapy. This paper describes a relationship between tracking lung motion using spirometry data and image registration of consecutive CT image volumes collected from a multislice CT scanner over multiple breathing periods. Temporal CT sequences from 5 individuals were analyzed in this study. The couch was moved from 11 to 14 different positions to image the entire lung. At each couch position, 15 image volumes were collected over approximately 3 breathing periods. It is assumed that the expansion and contraction of lung tissue can be modeled as an elastic material. Furthermore, it is assumed that the deformation of the lung is small over one‐fifth of a breathing period and therefore the motion of the lung can be adequately modeled using a small deformation linear elastic model. The small deformation inverse consistent linear elastic image registration algorithm is therefore well suited for this problem and was used to register consecutive image scans. The pointwise expansion and compression of lung tissue was measured by computing the Jacobian of the transformations used to register the images. The logarithm of the Jacobian was computed so that expansion and compression of the lung were scaled equally. The log‐Jacobian was computed at each voxel in the volume to produce a map of the local expansion and compression of the lung during the breathing period. These log‐Jacobian images demonstrate that the lung does not expand uniformly during the breathing period, but rather expands and contracts locally at different rates during inhalation and exhalation. The log‐Jacobian numbers were averaged over a cross section of the lung to produce an estimate of the average expansion or compression from one time point to the next and compared to the air flow rate measured by spirometry. In four out of five individuals, the average log‐Jacobian value and the air flow rate correlated well ( on average for the entire lung). The correlation for the fifth individual was not as good ( on average for the entire lung) and can be explained by the small variation in tidal volume for this individual. The correlation of the average log‐Jacobian value and the air flow rate for images near the diaphragm correlated well in all five individuals ( on average). These preliminary results indicate a strong correlation between the expansion/compression of the lung measured by image registration and the air flow rate measured by spirometry. Predicting the location, motion, and compression/expansion of the tumor and normal tissue using image registration and spirometry could have many important benefits for radiotherapy treatment. These benefits include reducing radiation dose to normal tissue, maximizing dose to the tumor, improving patient care, reducing treatment cost, and increasing patient throughput.

Low-Cost Structured Light Imaging of Regional Volume Changes for Use in Assessing Mechanical Ventilation

Color Structured Light System of Chest Wall Motion Measurement for Respiratory Volume Evaluation

Toward Respiratory Assessment Using Depth Measurements from a Time-of-Flight Sensor

Novel Spirometry Based On Optical Surface Imaging

Development and prospective in-patient proof-of-concept validation of a surface photogrammetry + CT-based volumetric motion model for lung radiotherapy

Deriving Pulmonary Ventilation Images From Clinical 4D-CBCT Using a Deep Learning-Based Model

Evaluation and Application of 3D Lung Warping and Registration Model Using HRCT Images

Predictive Modeling Of Lung Motion Over The Entire Respiratory Cycle Using Measured Pressure-Volume Data, 4dct Images, And Finite-Element Analysis

Non-Invasive Assessment of Abdominal/Diaphragmatic and Thoracic/Intercostal Spontaneous Breathing Contributions

A synthetic lung model (ASYLUM) for validation of functional lung imaging methods shows significant differences between signal-based and deformation-field-based ventilation measurements

WE-G-BRF-04: Robust Real-Time Volumetric Imaging Based on One Single Projection

&Lt;title>integrated Approach to 3D Warping and Registration from Lung Images</title>

Image-based Measurement of Alveoli Volume Expansion in an Animal Model of a Diseased Lung.

Reconstruction of a High-Quality Volumetric Image and a Respiratory Motion Model from Patient CBCT Projections.

Robust Real-Time Volumetric Imaging Based On One Single Projection

Camera-Based Respiratory Imaging for Intelligent Rehabilitation Assessment of Thoracic Surgery Patients

4D-Ct Motion Estimation Using Deformable Image Registration and 5d Respiratory Motion Modeling

Modelling approach to obtain regional respiratory mechanics using electrical impedance tomography and volume-dependent elastance model

Associating local strains to global pressure–volume mouse lung mechanics using digital image correlation

Tracking Lung Tissue Motion and Expansion/compression with Inverse Consistent Image Registration and Spirometry