Abstract:Cellulose nanocrystal and chitosan blended Nanocomposite for dye removal. Development of a cost‐effective and environmentally friendly method to treat dye wastewater is of utmost importance. In this experimental study, wastepaper was used as the raw material for the extraction of cellulose nanocrystals to fabricate a nanocomposite membrane with chitosan. During the extraction process, acid hydrolysis (Sulfuric acid) followed by bleaching (hydrogen peroxide) was adopted. To confirm the nano‐range, particle size analysis, and FESEM were performed, which confirmed the presence of particles in the nano‐range ranging from 313.8 to 122.1 nm and FESEM observed results showed transformation of fibrous to rod shaped nanocrystals after acid hydrolysis. After successful nanocomposite fabrication a porous sieved network of membrane was observed and after adsorption successful adhesion of dye molecules over the membrane matrix was also confirmed. FTIR data showed that during adsorption mechanism some of the prominent peaks gets disappeared suggest interaction of dye molecules onto the nanocomposite. The contact angle of 21.0° was observed for the ChNC3 nanocomposite showed super hydrophilic behavior. Tensile strength was also observed in terms of young's modulus, ultimate strength, and elongation at break. The elasticity and stiffness of a material are usually indicated by its young modulus. In AH CNCs and ChNC3, the young modulus was seen to be increasing from 195 0.316, respectively. Furthermore, the potentiality of the nanocomposite membrane was analyzed for Congo red dye in synthetic wastewater prepared in the laboratory. During the batch study, various working parameters were taken such as initial dye solution (20–100 ppm), pH (1–7), contact time (10–60 min), and dosage (0.1–0.5 mg/L). To know about adsorption, Langmuir and Freundlich isotherm were analyzed it was observed that Freundlich isotherm show best fitted modeling with R2 = 0.99, and n = 1.6 showing favorability of the heterogeneous adsorption. To determine the interaction between the adsorbate and adsorbent, pseudo first order and pseudo second order kinetics models were analyzed, and it was observed that chemisorption interaction followed between the adsorbate and adsorbent. Thermodynamic parameters were analyzed, which confirmed the spontaneous and favorable adsorption mechanism. To avoid fouling problems and maintain cost effectiveness, the resulting, nanocomposite membrane was desorbed using an appropriate solvent. After 5 cycles, the desorption rate decreased from 54% to 38%. This developed nanocomposite membrane appears to be effective in effluent waste treatment because of its simple formulation approach.

Removal of congo red dye from aqueous solution using nano ZnO/chitosan composite

Organic/Inorganic Nanocomposites of Zno/Cuo/Chitosan with Improved Properties

Efficient removal of Congo red using curcumin conjugated zinc oxide nanoparticles as new adsorbent complex

Adsorption of Congo Red from Aqueous Solution Onto Shrimp Shell Powder

Congo red adsorption on shell powder and chitosan-coated shell powder biosorbents: experiments and theoretical calculation

Insight into adsorption performance and mechanism of Congo red dye onto ZnFe 2 O 4 @ZIF-8 nanocomposite in water

Ultrahigh adsorption capacity of a new metal sieve-like structure nanocomposite-based chitosan-graphene oxide nanosheet coated with poly-o-toluidine for the removal of Acid Red dye from the aquatic environment

Nanoarchitectonics of Chitosan/Glutaraldehyde/Zinc Oxide as a Novel Composite for the Efficient Removal of Eriochrome Black T Dye from Aqueous Media

Removal of Congo Red dye from its aqueous solutions using NiFe-LDH and GO/NiFe-LDH composite materials as adsorbent

Eco-friendly approach for effective removal for Congo red dye from wastewater using reusable Zn-Al layered double hydroxide anchored on multiwalled carbon nanotubes supported sodium dodecyl sulfonate composites

Adsorption Properties of Congo Red from Aqueous Solution Onto N,O-carboxymethyl-chitosan

Highly Efficient Removal of Congo red from Wastewater by Nano-Cao

Green reduction of ZnO nanoparticles using cationic dialdehyde cellulose (cDAC) for efficient Congo red dye removal

Removal of Congo Red from Aqueous Solution Using A Chitosan/Organo-Montmorillonite Nanocomposite

Novel wastepaper nanocellulose/chitosan‐based nanocomposite membrane for effective removal of the textile dye Congo red from aqueous solution

A bio-nanocomposite of TiO2 NPs from mangrove (Avicennia marina) leaf and shrimp shell-based chitosan: sono-chemical synthesis, characterization, and its application as an adsorbent for anionic dye removal in a batch and continuous process

Adsorptive Removal of Congo Red Using Organically Modified Zinc–Copper–Nickel Ternary Metal Hydroxide: Kinetics, Isotherms and Adsorption Studies

Preparation and characterization of CS/β-CD/Nano-ZnO composite porous membrane optimized by Box-Behnken for the adsorption of Congo red

Zeolitic Imidazolate Framework-8/Graphene Oxide/magnetic Chitosan Nanocomposites for Efficient Removal of Congo Red from Aqueous Solution

Synthesis of ZnO@γ-Fe2O3 core–shell nanocomposites by a facile thermal decomposition approach and their application in photocatalytic degradation of congo red

Composite adsorbents of aminated chitosan @ZIF-8 MOF for simultaneous efficient removal of Cu(II) and Congo Red: Batch experiments and DFT calculations