Abstract:Background: Combined infrared (CIR) and convective drying is a promising technology in dehydrating heat-sensitive foods, such as fruits and vegetables. This novel thermal drying method, which involves the application of infrared energy and hot air during a drying process, can drastically enhance energy efficiency and improve overall product quality at the end of the process. Understanding the dynamics of what goes on inside the product during drying is important for further development, optimization, and upscaling of the drying method. In this study, a multiphase porous media model considering liquid water, gases, and solid matrix was developed for the CIR and hot-air drying (HAD) of sweet potato slices in order to capture the relevant physics and obtain an in-depth insight on the drying process. The model was simulated using Matlab with user-friendly graphical user interface for easy coupling and faster computational time. Results: The gas pressure for CIR-HAD was higher centrally and decreased gradually towards the surface of the product. This implies that drying force is stronger at the product core than at the product surface. A phase change from liquid water to vapour occurs almost immediately after the start of the drying process for CIR-HAD. The evaporation rate, as expected, was observed to increase with increased drying time. Evaporation during CIR-HAD increased with increasing distance from the centreline of the sample surface. The simulation results of water and vapour flux revealed that moisture transport around the surfaces and sides of the sample is as a result of capillary diffusion, binary diffusion, and gas pressure in both the vertical and horizontal directions. The nonuniform dominant infrared heating caused the heterogeneous distribution of product temperature. These results suggest that CIR-HAD of food occurs in a non-uniform manner with high vapour and water concentration gradient between the product core and the surface. Conclusions: This study provides in-depth insight into the physics and phase changes of food during CIR-HAD. The multiphase model has the advantage that phase change and impact of CIR-HAD operating parameters can be swiftly quantified. Such a modelling approach is thereby significant for further development and process optimization of CIR-HAD towards industrial upscaling. © 2020 Society of Chemical Industry.

Drying characteristics of thin layer of potato (Solanum tuberosum): experimental and computational studies

An experimental investigation on a locally fabricated dryer integrated with a novel solar air heater for the drying of potato slices

Design and Fabrication of Solar Dryer System for Food Preservation of Vegetables or Fruit

Eco-thermal Analysis and Response Surface Optimization of the Drying Rate of Potato Slices in a Mix-Mode Solar Dryer

Mathematical modelling of drying kinetics, economic and environmental analysis of natural convection mix-mode solar and sun drying of pre-treated potato slices

A Comparative Management Analysis on the Performance of Different Solar Drying Methods for Drying Vegetables and Fruits

Heat and Mass Transfer, Quality, Performance Analysis, and Modeling of Thin Layer Drying Kinetics of Banana Slices

A fully coupled multiphase model for infrared-convective drying of sweet potato

Analysis of the Heat Transfer Coefficient, Thermal Effusivity and Mathematical Modelling of Drying Kinetics of a Partitioned Single Pass Low-Cost Solar Drying of Cocoyam Chips with Economic Assessments

Experimental Investigation on a Solar Assisted Heat Pump In-Store Drying System

Experimental investigation of a hybrid solar dryer for vegetable drying with and without phase change material

Development, validation, and comparison of FE modeling and ANN model for mixed-mode solar drying of potato cylinders

Efficient simulation of bitter gourd drying in active solar dryer: A state-of-the-art model

Comparison of different solar dryers with and without heat storage for crop drying: A review

Semi-empirical thin-layer drying model for the agricultural products

Machine learning, mathematical modeling and 4E (energy, exergy, environmental, and economic) analysis of an indirect solar dryer for drying sweet potato

Experimental studies on natural convection open and closed solar drying using external reflector

Investigation of thermal performance, drying characteristics and environomical analysis: direct flow evacuated tube solar drying of okra

Assessing thermal and economic performance of solar dryers in sustainable strategies for bottle gourd and tomato preservation

Experimental investigation of thermal performance of indirect mode solar dryer with phase change material for banana slices

Design and Development of Domestic Solar Dryer with Comparative Analysis of Nutritional Aspect of Dried Raisins