Abstract:This research aims to design and construct an electronic notice as an alternative to the traditional signpost parting on walls and billboards by providing practical, reliable and proper information dissemination. They consist of the following units, the power supply, voltage regulators, GSM modules, microcontroller, LED dot matrix display board, counter and subscriber identity module (SIM). The power supply comprises a 240/9 v ac 50 Hz step-down transformer rectifier filter and voltage regulations. AT89852, a low-power, high-performance CM05 8-bit microcontroller with 8 k bytes in-system programmable flash memory, is used in this design. A constant five v de is required to power microcontrollers and their associated input/output channel. GSM Modern is a wireless device that works with a GSM wireless network. The counter circuit of the device used to achieve this type of counting is the 5-stage Johnson decade counter. It is a typical chip in the 74HC555, with ten decoded outputs that go high one at a time. The assembler used for this research is MLAB version 5.7, downloaded from the microchip website. This window-based integrated development environment (IDE) software supports the PIC and other microcontrollers. The project constitutes both the software and hardware section for successful implementation. Operation more focus was given to the contribution of the system hardware. For verification of proper functionality of the message board, variation tests carry out and their results. Each component was carefully tested, and hardware troubleshooting and software debugging were carried out. The message was sent, and it appeared and started moving from left to right. In conclusion, by introducing the concept of wireless technology in communication, we can make our communication more efficient and faster with excellent efficiency, and the message can be displayed with less error and maintenance. This model can be used efficiently in establishments like colleges where in-order and special discounts can be displayed simultaneously at all branches. It is therefore recommended as a conventional model can say more than one message at a time LEDS have a limitation on size and a good number of characteristics. These can be replaced with large LED display boards, which not only catch bulb display attributes in a moving position one after another.

Indoor LED videotron screen design with microcontroller HD-U60-75

Voxel Drawing and Simulation for Multi-Color Three-Dimensional Volumetric Display System

Perancangan dan Realisasi Automatic Dimming Light

Design of New LED Curtain Wall Controller and Its Effect in Architectural Decoration

Design of Digital Squeeze Frame Console for Public Service Advertisement

70.3: Novel Single Panel Projection Systems

Circuit Design of Single Panel Color LCOS Microdisplay Chip

Novel single panel projection systems

Modelling of lighting system utilizing natural and artificial lighting using DIALux

Design and Construction of a Modified SMS-Based Electronic Notice Board

Perancangan Sistem Penjadwalan Penerangan Lampu pada Smart Building Berbasis PLC dan HMI

Prototype of implementation of hybrid visible light communication technology for tele controlling systems in archives warehouse

Design and Construction of a Microcontroller Based Electronic Moving Message Display

Efektivitas Ilusi 3D Animasi Blender Pada Curved Led Billboard (Ab Building Jl. Juanda Pekanbaru)

IoT CONTROLLED LED NOTICE BOARD

Design and Simulation of Dynamic Display LED Based on Single-chip Microcontroller

Design of Full_Color LED Display Panel System Based on STM32

Design of Automatic Watering and Humidity Systems Based on Internet of Things for Screenhouse

Design a Realtime Datalogger on a Simple House KWH Meter with a Capacity of 1300 VA

To Build a Novel HDR/WCG Display Model

Design of Light Emitting Diodes (LEDs) Lighting System and Its Application in Garden Landscape Decoration