Abstract:Carbon/polymer binder composite bipolar plates for proton exchange membrane fuel cells have attracted attention for their corrosion resistivity and ease of manufacturing. However, the hot-pressing fabrication process often leads to a resin-rich surface on the plate, which may increase the interfacial contact resistance. A number of studies have been reported to reduce resin accumulation on the surface. However, most reported methods have focused on how to exceed the United States Department of Energy conductivity and mechanical targets. Their fabrication methods are often complicated, which is hard to form flow channels directly in manufacturing. Herein, we propose a simple layer-by-layer method to prepare graphite/resin composite bipolar plates. During compression of the multilayer graphite/resin powder, elevated temperature and pressure make the resin in the inner polymer-rich layer flow toward the outer resin-deficient layers. Scanning electron microscopy with energy-dispersive X-ray analysis shows an unbroken “smiling” curve of carbon content along the whole cross-section, suggesting a continuous distribution of the resin across the whole composite. The resulting composite demonstrates a better interfacial contact resistance (9.2 mΩ cm2@100 psi) and a flexural strength (44.3 MPa) than the plates prepared by a single-layer method. Flow channels with a good molding accuracy (±4 μm) are also observed. Single-cell testing with the gradient-structured composite plate shows excellent cell performance: the cell voltage is 0.67 V at 1 A cm–2, and the maximum power density reaches 0.99 W cm–2. In situ electrochemical impedance analysis demonstrates that compared to an analogue using the single-layer loading method, the cell with gradient structured plates displays lower ohmic and mass transfer resistance than the cell using the plates prepared by a single-layer method.

Optimization Scheme of Bipolar Plate for Hydrogen Fuel Cell

Bipolar Plate Flow Field Structure Research Status and Trends for Hydrogen Fuel Cell Vehicles

Development Status of Flow Field Design for Bipolar Plates in Hydrogen Fuel Cells

Effect of bipolar-plates design on corrosion, mass and heat transfer in proton-exchange membrane fuel cells and water electrolyzers: A review

Optimization of Fuel Cell Performance Using Computational Fluid Dynamics

Modeling, design, materials and fabrication of bipolar plates for proton exchange membrane fuel cell: A review

Problems in the Manufacture of Hydrogen Fuel Cells Bipolar Plates

Research Progress and Prospects of Bipolar Plate Materials for Proton Exchange Membrane Fuel Cells

PERFORMANCE ANALYSIS OF A BIPOLAR PLATE IN A FUEL CELL USING COMPUTER FLUID DYNAMICS STUDIES

Current status of research on composite bipolar plates for proton exchange membrane fuel cells (PEMFCs): nanofillers and structure optimization

Bipolar Plate Design Assessment: Proton Exchange Membrane Fuel Cell and Water Electrolyzer

Development of Novel Single Fuel Cell Based on Composite Polar Plates for Highly Efficient Power Generation

Effect of Bipolar Plate Material on Proton Exchange Membrane Fuel Cell Performance

Materials and Preparation of Bipolar Plates in PEMFC

Testing Study of Different Flow Direction and Structure for Air-Cooled Proton Exchange Membrane Fuel Cell

Bipolar plate design and fabrication using graphite reinforced composite laminate for proton exchange membrane fuel cells

Studies of Electrocatalyst and Metallic Bipolar Plate for Polymer Electrolyte Fuel Cell

Investigation and optimization of the ultra-thin metallic bipolar plate multi-stage forming for proton exchange membrane fuel cell

Effect of Metallic Bipolar Plates Fillet Radii on Fuel Cell Performance

Optimization of variable cross-sectional flow channel parameters for fuel cells: Numerical analysis and distributional uniformity evaluation

Gradient Structured Composite Bipolar Plates for Proton Exchange Membrane Fuel Cells