Abstract:Face-centered cubic (FCC) high/medium entropy alloys (HEAs/MEAs), novel multi-principal element alloys, are known to exhibit exceptional mechanical properties at room temperature; however, the origin is still elusive. Here, we report the deformation microstructure evolutions in a tensile-deformed Co 20 Cr 40 Ni 40 representative MEA and Co 60 Ni 40 alloy, a conventional binary alloy for comparison. These FCC alloys have high/low friction stresses, fundamental resistance to dislocation glide in solid solutions, respectively, and share similar other material properties, including stacking fault energy. The Co 20 Cr 40 Ni 40 MEA exhibited higher yield strength and work-hardening ability than in the Co 60 Ni 40 alloy. Deformation microstructures in the Co 60 Ni 40 alloy were marked by the presence of coarse dislocation cells (DCs) regardless of grain orientation and a few deformation twins (DTs) in grains with the tensile axis (TA) near 〈1 1 1〉. In contrast, the MEA developed three distinct deformation microstructures depending on grain orientations: fine DCs in grains with the TA near 〈1 0 0〉, planar dislocation structure (PDS) in grains with other orientations, and a high density of DTs along with PDS in grains oriented 〈1 1 1〉. Three-dimensional electron tomography revealed that PDS in the MEA confined dislocations within specific {1 1 1} planes, indicating suppression of cross-slip of screw dislocations and dynamic recovery. In-situ X-ray diffraction during tensile deformation showed a higher dislocation density in the MEA than in the Co 60 Ni 40 alloy. These findings demonstrate that FCC HEAs/MEAs with high friction stresses naturally develop unique deformation microstructures which is beneficial for realizing superior mechanical properties compared to conventional materials.

Cyclic Deformation Behavior of an Equiatomic CrFeNi Multi-Principal Element Alloy

Low cycle fatigue behavior of nickel-based superalloy GH4145/SQ at elevated temperature

Multi-scale Deformation Behavior Investigation of 18cr–8ni Austenitic Steel Subjected to Low-Cycle Fatigue Loading

Compositional Undulation Induced Strain Hardening and Delocalization in Multi-Principal Element Alloys

Deformation mechanisms of CoCrFeMnNi high-entropy alloy under low-cycle-fatigue loading

Uncovering wear mechanism of a Fe2Ni2CrAl multi-principal elements alloy

Influence of Strain Amplitude on Low-Cycle Fatigue Behaviors of a Fourth-Generation Ni-Based Single-Crystal Superalloy at 980 °C

Unveiling the Precipitation Behavior and Mechanical Properties in G-phase Strengthened CrFe2Ni2Ti0.2Six Multi-Principal Element Alloys

Cooperative deformation mechanisms in a fatigued CoCrNi multi-principal element alloy: A case of low stacking fault energy

Cyclic plasticity and fatigue damage of CrMnFeCoNi high entropy alloy fabricated by laser powder-bed fusion

Temperature-dependent cyclic deformation behavior of CoCrFeMnNi high-entropy alloy

Fatigue Behaviour and Crack Initiation in CoCrFeNiMn High-Entropy Alloy Processed by Powder Metallurgy

Phase transformation - induced strengthening of an additively manufactured multi- principal element CrMnFeCoNi alloy

In situ neutron diffraction study of fatigue behavior of CrFeCoNiMo0.2 high entropy alloy

Effect of Fe content on microstructures and mechanical properties of eutectic Co-Cr-Fe-Ni-Hf multi-principal element alloys

Computational design of non-equiatomic CoCrFeNi alloys towards optimized mechanical and surface properties

A Novel Martensitic-Like Transformation Fe-Based Multi-principal Element Alloy

Characteristic deformation microstructure evolution and deformation mechanisms in face-centered cubic high/medium entropy alloys

Microstructure, strength and irradiation response of an ultra-fine grained FeNiCoCr multi-principal element alloy

Insight into the microstructure and micromechanical behavior and mechanism of the constitutional phase of FeNiCrAl 0.63 multi-principal element alloy

Low cycle fatigue performances of Al 0.3 CoCrFeNi high entropy alloys: In situ neutron diffraction studies on the precipitation effects