Abstract:A substantial body of evidence suggests that indoor mold exposure is a cause of allergic and respiratory diseases in humans. While models exist for assessing the risk of mold growth on building materials, few study the characteristics of mold growth after germination. This study conducted mold growth experiments in a constant temperature chamber, using four temperature settings of 15, 20, 25 and 30 °C, and three relative humidities of 56 to 61%, 75 to 76% and 83 to 86%. A mold growth prediction model was established using temperature and relative humidity. The accuracy of the model was verified by comparing the sampling and the predicted values in a laboratory environment. The results indicated that reducing the environmental temperature and relative humidity could significantly inhibit the growth of mold, although the inhibitory effects varied. Temperature might play a more critical role. At higher temperatures (25 °C and 30 °C), the growth rate and lag time of mold tended to be consistent and there were differences in the maximum diameter. In the predictive model, the polynomial secondary model for the maximum growth rate and lag time and the Arrhenius–Davey secondary model for the maximum diameter (A) had good predictive effects (Adj.R2 > 0.850). It is speculated that temperature is the key factor affecting the maximum growth diameter of mold. The mold growth prediction model could better predict the growth of mold in actual environments without wind Adj.R2 > 0.800), but the accuracy of the model decreased under windy conditions (wind velocity < 1 m/s). The mold growth predictive model we established could be used to predict the growth characteristics of mold in windless environments. It also provides control suggestions for the regulation of temperature and relative humidity in indoor environments, supporting indoor thermal environment management and pollutant control, and ensuring indoor human health.

Mold growth on pine and spruce wood: Dependence on moisture content, anatomical direction, and mold species

Mold growth on spruce and pine samples in steady state conditions: Time of germination and maximum coverage

Risk Assessment of Mold Growth on Engineered Bamboo and Its Application

Hyphal growth of Penicillium rubens in changing relative humidity

A Predictive Model for the Growth Diameter of Mold under Different Temperatures and Relative Humidities in Indoor Environments

Mould growth on building materials under low water activities. Influence of humidity and temperature on fungal growth and secondary metabolism

Comparative studies on the durability and moisture performance of wood modified with cyclic N-methylol and N-methyl compounds

Toward a logistic model of dynamic mold growth on wood

Water film in very high humidity inhibits mold growth on the damp surface of soil ruins

The Moisture Distribution in Wall-to-floor Thermal Bridges and Its Influence on Mould Growth

Temperature versus Relative Humidity: Which Is More Important for Indoor Mold Prevention?

Experimental investigation of mold growth risk among typical residential indoor materials: Case study in coastal city, China

Effects of mold growth on building materials by different environments in Taiwan

A microscopy study of hyphal growth of Penicillium rubens on gypsum under dynamic humidity conditions

Wood modification with N-methylol and N-methyl compounds: a case study on how non-fixated chemicals in modified wood may affect the classification of their durability

Needle Damage Development in Norway Spruce Seedlings as Affected by Humidity, Temperature, and Gray Mold: A Preliminary Study

The effect of using wood chips exposed to mold fungi on the properties of chipboard

Important factors affecting the risk of mold growth in well-insulated wood frame walls in Northern European climates

Influence of surface modification of wood with octadecyltrichlorosilane on its dimensional stability and resistance against Coniophora puteana and molds