Abstract:A substantial body of evidence suggests that indoor mold exposure is a cause of allergic and respiratory diseases in humans. While models exist for assessing the risk of mold growth on building materials, few study the characteristics of mold growth after germination. This study conducted mold growth experiments in a constant temperature chamber, using four temperature settings of 15, 20, 25 and 30 °C, and three relative humidities of 56 to 61%, 75 to 76% and 83 to 86%. A mold growth prediction model was established using temperature and relative humidity. The accuracy of the model was verified by comparing the sampling and the predicted values in a laboratory environment. The results indicated that reducing the environmental temperature and relative humidity could significantly inhibit the growth of mold, although the inhibitory effects varied. Temperature might play a more critical role. At higher temperatures (25 °C and 30 °C), the growth rate and lag time of mold tended to be consistent and there were differences in the maximum diameter. In the predictive model, the polynomial secondary model for the maximum growth rate and lag time and the Arrhenius–Davey secondary model for the maximum diameter (A) had good predictive effects (Adj.R2 > 0.850). It is speculated that temperature is the key factor affecting the maximum growth diameter of mold. The mold growth prediction model could better predict the growth of mold in actual environments without wind Adj.R2 > 0.800), but the accuracy of the model decreased under windy conditions (wind velocity < 1 m/s). The mold growth predictive model we established could be used to predict the growth characteristics of mold in windless environments. It also provides control suggestions for the regulation of temperature and relative humidity in indoor environments, supporting indoor thermal environment management and pollutant control, and ensuring indoor human health.

Water film in very high humidity inhibits mold growth on the damp surface of soil ruins

Quantitative Analysis of Mold Growth Differences on Surfaces in Damp Soil Ruins Affected by Ventilation and Lighting Modes: Soil Ruin Exhibition Halls in High-humidity Regions

Mold Growth under Near-Saturated Preservation Environment of Unearthed Relics Within Archaeological Museums

Risk Assessment of Mold Growth on Engineered Bamboo and Its Application

The Moisture Distribution in Wall-to-floor Thermal Bridges and Its Influence on Mould Growth

Facilitator of moisture accumulation in building envelopes and its influences on condensation and mould growth

Experimental investigation of mold growth risk among typical residential indoor materials: Case study in coastal city, China

Effects of mold growth on building materials by different environments in Taiwan

Current challenges for shaping the sustainable and mold‐free hygienic indoor environment in humid regions

The Effect of Air leakage through the Air Cavities of Building Walls on Mold Growth Risks

Temperature versus Relative Humidity: Which Is More Important for Indoor Mold Prevention?

Analysis of evaporation–condensation cycles at archaeological earthen sites preserved under high-humidity conditions

A Predictive Model for the Growth Diameter of Mold under Different Temperatures and Relative Humidities in Indoor Environments

Correlation of Environmental Parameters and the Water Saturation Induced Deterioration of Earthen Archaeological Sites: the Case of World Heritage Liangzhu City, China

Impact of Air Velocity on Mold Growth in High Temperature and Humidity Conditions: An Experimental Approach

Mold growth on spruce and pine samples in steady state conditions: Time of germination and maximum coverage

Long-term Investigation of Moisture Environment in Underground Civil Air Defence Work