Analyzing the bond strength between lightweight concrete and lightweight polyester-polymer concrete

Mohammad Mahdi Shiravi,Mohammad Reza Eftekhar

DOI: https://doi.org/10.1007/s41062-022-01012-6

2022-12-28

Innovative Infrastructure Solutions

Abstract:With high mechanical strength, low permeability, and high endurance in harmful conditions as advantageous features, polymer concrete has recently become an issue of interest among researchers in this field. For retrofitting of reinforced concrete structures or applying it in specific settings, lowering its weight by applying lightweight particles would increase its advantages. It is essential to attain the required strength and adhesion between the existing concrete and the fresh repairable concrete to enhance reinforced concrete structures. The high cost of making polymer concrete is one of its drawbacks that restricts its application. Adding a thin layer of this concrete to reinforce and upgrade structural components can overcome this drawback. The objective is to assess how well the conventional light concrete adheres to polymer light concrete and vice versa when applied as a coating. The effect of drilling and sandblasting techniques applied in preparing the substrate concrete surface is assessed as well. In addition to the beneficial features of polyester-polymer concrete, its low cost makes it a viable alternative for this type of application. The studies on this concrete type are fewer than those on epoxy polymer concrete. The surface preparation method of the substrate concrete by sandblasting and drilling holes followed by applying this adhesive layer of new polymer concrete coating would yield the maximum adhesion strength. Preparation of surface by sandblasting results in bond strengths of 88.9% and 112.5% higher than applying holing method and no surface preparation. Only applying fresh polymer concrete (with or without resin) on the sandblasted surface of light concrete increases bond strength above 10 MPa compared to different techniques of combining two types of concrete. This bond strength meets the ACI regulation.