Abstract:Urban development and rapid extension of cities have been accompanied by considerable growth in excavation projects. Soil nail walls have been found to be an economical solution to many soil reinforcement and excavation support problems. To overcome some of the intrinsic problems with the conventional grout soil nails, screw soil nails were developed in recent years that provide several advantages over grouted soil nails. Tabriz marl outcrops at considerable parts of this city. Considering the rapid development of the Tabriz (as one of the biggest industrial cities of Iran), a large part of new urban areas and industrial zones will be located on marl soils. Therefore, it is necessary to evaluate the efficiency of the screw nailing method in Tabriz marl soils. In the present study, the performance of the walls reinforced by screw and grouted nails in different types of Tabriz marls was studied. For this purpose, a three-dimensional (3D) modeling is performed using the ABAQUS software. The results of the numerical analyses revealed that the failure zone of the screw and grout nailed walls is similar and consisting of parts entitled A and B. There is no significant difference between the characteristics of part B at both of the screw nailing and grout nailing methods. While, the A part of the failure zone and the maximum soil displacements in this part at the screw nailing method are smaller than those of the grout nailing method. At all types of the Tabriz marl, the lateral and vertical displacements of the reinforced walls by screw nails are smaller than those of grout nails, and in the case of yellow marl, the difference is considerable, while, at brown marl, it is negligible. The results of analyses show that the screw nail performs better than the pressurized cement grouted nail in terms of wall displacement. The efficiency of the screw nails increases in comparison to grouted nails by proceeding with the excavation process. At yellow marl because of lower elastic modulus value, the performance of the screw and grouted nails is more obvious than the other types of marl. The rate of increase in settlement values and maximum settlement of the soil for screw nailed walls are smaller than those of grout nailed walls. Also, the settlement profile of ground surface behind the wall is consisting of two parts, including critical and non-critical parts. The difference in the behavior of the screw and grouted nailed walls is obvious in the critical part of the soil behind the wall.

Seismic amplification factor and dynamic response of soil-nailed walls

Assessment of the Pseudo-static seismic behavior in the soil nail walls using numerical analysis

ANALYSIS ON SOIL-NAILED RETAINING STRUCTURE USING ENERGY METHOD

Analysis of Behavior of Nailing Supported Mixed Soil-Cement Wall in Excavation

Seismic behavior of multi-story structural walls under cyclic lateral loading: Experimental study

Nail Reinforcement Mechanism of Cohesive Soil Slopes under Earthquake Conditions

Integrating soil-nailed walls with RC building for seismic stability in space-constrained sites

Seismic performance and damage incurred by monolithic concrete self-centering rocking walls under the effect of axial stress ratio

Seismic analysis of the soil–structure interaction for a high rise building adjacent to deep excavation

Performance Evaluation of the Screw Nailed Walls in Tabriz Marl

Study on Seismic Amplification Effect and Active Earth Pressure of Retaining Wall Based on Pseudo-Dynamic Method and Numerical Simulation

Pseudo-static analysis of reinforced earth retaining walls

Novel performance‐based seismic reinforcement method for the dry masonry retaining wall located in an urban residential area

Estimating System Stiffness of Soil Nailing Wall for Deep Excavation in Clay

Assessment of the Seismic Performance and the Base Shear Contribution Ratios of the RC Wall-frame Dual System Considering Soil–Structure Interaction

Influence of Various Earth-Retaining Walls on the Dynamic Response Comparison Based on 3D Modeling

Pullout Behavior of Nail Reinforcement in Nailed Soil Slope

Optimization of geometric parameters of soil nailing using response surface methodology

Dynamic response of a tall building next to deep excavation considering soil–structure interaction

Evaluation of the Active and Passive Pseudo-dynamic Earth Pressures using Finite Element Limit Analysis and Second-order Cone Programming

Nonlinear Seismic Response Based on Different Site Types: Soft Soil and Rock Strata