Abstract:The ongoing depletion of shallow resources has led to the mining of progressively deeper deposits, where high-temperature thermal stresses pose heat hazards and threaten worker safety. Mitigating geothermal hazards is therefore an essential component of mining operations in deep mines. In this paper, a novel synergetic mining approach is proposed that controls heat hazards at low cost and simultaneously exploits mineral and geothermal energy. Injection and production channels are designed below the ventilation tunnel to synchronously cool the tunnel surrounding rock and exploit mine geothermal energy. A fully coupled numerical model is established that simultaneously simulates heat and mass transfer in a large-scale ventilation network and geological reservoir. The cooling effect on the tunnel and heat recovery capacity of geothermal exploitation are investigated to assess the feasibility of the proposed scheme. Three case studies are presented to identify the impact of the water injection and production channel layout on the heat and mass transfer characteristics in the rock layer. The temperature of the tunnel surrounding rock is cooled over a few years via low-temperature water injection into the mine and heat production in the deep rock layer; this rapidly reduces the air temperature inside the tunnel. The total heat production rate initially rapidly increases and then gradually decreases. In the ninth year, the maximum heat production rate of the production channel reached 6.01 × 103 kW. The cooling effect on the roadway and heat production performance are optimal when the water injection channel is arranged under the air intake side of the main ventilation roadway of the mine and the heat production channel is arranged in the deep rock under the return air side of the roadway. After 4 years of water injection, the temperature at the end of the tunnel in Case 1 rapidly decreased to 30.9°C; this temperature is 6.6°C and 3.4°C lower than those in Cases 2 and 3, respectively. Longer injection channel lengths can significantly reduce the injection pressure requirement in the injection channel. Shorter distances between the injection channel and tunnel are associated with faster reductions of the tunnel temperature. This technique significantly improves the thermal comfort inside the tunnel and produces considerable geothermal energy; a single heat production channel can produce 1.68 × 1015 J over a period of 10 years.

Enhancement technology of underground water flow field in coal mine to improve energy efficiency of heat pump system in geothermal energy development

Some Studies on Geotechnical Engineering Technology of Ground Source Heat Pump System

Efficiency Improvement and Application of the Groundwater Heat Pump Cooling System in Linglong Gold Mine

Optimizing the Layout of a Ground Source Heat Pump System with a Groundwater–Thermal Coupling Model

Analysis of the Heat Transfer Performance of a Buried Pipe in the Heating Season Based on Field Testing

Long-term Performance Evaluation and Economic Analysis for Deep Borehole Heat Exchanger Heating System in Weihe Basin

Heat transfer characteristics of buried pipes under groundwater seepage in Karst regions

Influence of underground drop seepage on temperature field in the buried pipe zone and performance of ground source heat pump system

Study on the simulation and optimization of the heat transfer scheme in a buried-pipe ground-source heat pump

Numerical simulation of ground temperature field changein underground heat transfer zone of ground sourceheat pump under different groundwater runoff conditions

Some Critical Points to Shallow Geothermal Energy Mining Using Groundwater Source Heat Pumps

Research on Underground-Water Source Heat Pump's Water Source

A geothermal energy heat exchange system suitable for abandoned mines and its optimization

Experimental Study on Operating Characteristic of the System of Ground Source Heat Pump Combined with Floor Radiant Heating of Capillary Tube

Synergetic mining of geothermal energy in deep mines: An innovative method for heat hazard control

Performance of Ground Source Absorption Heat Pump

Research on the thermal balance of a novel independent heat extraction-release double helix energy pile in long-term operation

Study on Heat Transfer Performance and Parameter Improvement of Gravity-Assisted Heat Pipe Heat Transfer Unit for Waste Heat Recovery from Mine Return Air

Comparative study of novel backfill coupled heat exchangers using different waste materials in underground stopes

Research on thermal performance of ground source heat pump based on artificial neural network predictive model

Waste heat recovery, utilization and evaluation of coalfield fire applying heat pipe combined thermoelectric generator in Xinjiang, China