Effects of humidity on tribological properties of 8YSZ/C coating designed by the combination of thermal spraying and hydrothermal reaction

Wen Deng,Chuanyun Zhang,Junde Guo,Jingjing Zhang

DOI: https://doi.org/10.1002/adem.202300761

IF: 3.6

2023-11-14

Advanced Engineering Materials

Abstract:Thermal spraying ceramic coatings have been widely used to prevent wear damage. However, the poor lubricating ability seriously restricted their application. In this paper, zirconia stabilized by 8 wt% yttria (8YSZ)‐C composite coating is prepared with the combination of in‐situ synthesis carbon microspheres in the pores of as‐sprayed 8YSZ coating by hydrothermal reaction. The chemical constituents and morphologies of the synthesized powders and the composite coatings are analyzed by SEM and XRD. The microstructure and tribological behaviors of the composite coating are studied by SEM, TEM and Raman analysis. The influence of humidity on the structural evolution of carbon microspheres during sliding wear process is discussed. The results show that the synthetic C powders exhibit a typical spherical structure. Meanwhile, carbon microspheres adhere to the pores of the 8YSZ coating. The friction and wear experiments in different humidity show that the re‐graphitization of amorphous carbon becomes extremely obvious with the increase of humidity. Under the 80% humidity, an ordered graphene nanoscroll structure is formed, resulting in the optimization of the tribological properties. Furthermore, the friction coefficient of composite coating is reduced to 0.18, and its wear rate is about 1 times lower than that of under the 10% humidity. This article is protected by copyright. All rights reserved.

materials science, multidisciplinary