Abstract:<p>The unmitigated heat flux in attached operation of a fusion power plant is predicted to be destructive to any solid divertor surface. Detachment, whereby the plasma pressure drops significantly before reaching the divertor target thus greatly reducing the heat flux and sputtering, will be necessary to ensure adequate lifetime of plasma facing components (PFCs). The lithium vapor box divertor aims to detach the divertor plasma via evaporating and condensing lithium surfaces. By evaporating lithium near or at the divertor plate and condensing it closer to the main chamber, a lithium vapor density gradient can be created. This density gradient ties energy losses to poloidal distance between the target and the detachment point. The radiation zone is then prevented from reaching the X-point as the lithium ionization rate decreases when the detachment front moves away from the divertor target. Here we present Scrape Off Layer Plasma Simulator (SOLPS) simulations of a lithium vapor box divertor using an NSTX-U equilibrium and PFC geometry. The parameters for the core boundary conditions, gas puff intensity, and heat and particle transport coefficients are chosen to match experimental values. Acceptable agreement with experimental Scrape-Off Layer (SOL) widths is found, indicating a reasonable choice of transport coefficients. In predictive simulations, lithium is added via evaporation at the target. Predictions for peak heat fluxes and upstream impurity concentration are given for a variety of evaporation rates. Target electron temperature is predicted to be able to be reduced to recombination levels (below 1 eV) for lithium evaporation rates of <span class="math"><math>1⋅1023</math></span> Li/s, indicating detachment. Peak heat flux at the lower outer target could be reduced by as much as a factor of six while maintaining upstream lithium fractions below 2%. The prevention of lithium from reaching the midplane is shown to be due to an increase in frictional forces acting on the lithium from a deuterium gas puff. Lithium is also shown to be redeposited close to the evaporator which is favorable for initial tests and future capillary porous systems.</p>

SOL impurity transport analysis with SONIC code with a kinetic effect on a thermal force transport model in JT‐60U

Impact of Impurity Mixture Gas Seeded by Supersonic Molecular Beam Injection on Edge-Localized Modes in the HL-2A Tokamak

Overview of Hl-2a Experiment Results

Electric Probe Measurements at Edge Region During H‐Mode Discharges in KSTAR

Estimation of impact of non‐local ion heat flux model on transport simulation for DEMO‐relevant scrape‐off layer plasma

Impurity Mode Induced Turbulent Particle Transport and Its Temperature Screening Effect

Modeling turbulent impurity transport in the SOL of DIII-D with a reduced model

The impact of non-local parallel electron transport on plasma-impurity reaction rates in tokamak scrape-off layer plasmas

Study of Electromagnetic Mode Contributing Inward Particle Pinch in the Scrape-off Layer During H-mode Discharge

Reduced Physics Model of the Tokamak Scrape-off-Layer for Pulse Design

Theory-based scaling laws of near and far scrape-off layer widths in single-null L-mode discharges

Evaluation of SPARC divertor conditions in H-mode operation using SOLPS-ITER

Simulation of plasma current ramp-up with reduced magnetic flux consumption in JT-60SA

Simulations of the stationary Q=10 and the exit phase from the flat-top of an ITER 15MA baseline scenario Predictive JINTRAC simulations with consistent treatment of D and T in the whole plasma

Impurities in a non-axisymmetric plasma: Transport and effect on bootstrap current

Improved scaling of the scrape-off layer particle flux width by the Bayes theorem on EAST

Predictive modeling of a lithium vapor box divertor in NSTX-U using SOLPS-ITER

Collisional radiative modelling with improved cross sections to investigate plasma molecular interactions in divertor plasmas

Analysis and design of Fast Flow Liquid Li Divertor for Fusion Nuclear Science Facility (FNSF) using coupled plasma boundary and LM MHD/heat transfer codes

Investigation of atomic and molecular rates in plasma-edge simulations through experiment-simulation comparisons

Characterization of SOL profiles and turbulence in ICRF-heated plasmas in EAST