Abstract:ABSTRACTDeveloped more than 80 years ago, the design procedure of concrete filled steel tubes (CFST) has several limitations that can still be found in most current international design standards. The two main limitations that present themselves are the lack of ability to achieve material enhancement when using high strength materials and restrictions on the geometry of the steel tube thickness to the overall column diameter. This geometric limitation is placed on the design to ensure that the steel tube remains ‘compact’. In complying with these constraints it is assumed in the design equations that local buckling of the steel tube will not take place before the ultimate global buckling load is achieved.With the introduction of higher strength materials, specifically when dealing with steel, the strength increase leads to the design of sections with increased slenderness. As the section becomes more slender, the ability to maintain the compact section limitations in the design codes becomes increasingly difficult. This paper looks at an experimental study on very thin‐walled steel tubes filled with high‐strength concrete and how localised buckling affects their compressive capacity.Adopting a diameter to thickness ratio of 200, 24 circular tubes were constructed using a high‐strength cold‐formed steel sheet, with yield stresses above 500MPa and filled with 100MPa concrete. Employing both thin‐walled sections and high strength materials, the effects of localised buckling in these composite members when subjected to compression has been studied. The experimental programme explored four main conditions; when both the steel and concrete were loaded and bonded together, when the concrete core inside the CFST was loaded, when the steel tube in the CFST was loaded and when the concrete core without the steel tube was tested.By studying the failure modes of both the concrete and the steel tube when acting compositely and individually, the experimental work shows that there is valid evidence to support the theory that even when using high strength materials in slender sections, confinement to the concrete core is provided. Finally, the results of the experimental work have been compared to the compressive design capacities predicted by current international design codes, showing that these provisions are conservative.

Experimental study on self-compacting concrete-filled steel tube samples containing shrinkage-controlling admixtures

Compressive Behavior of GFRP Tubes Filled with Self-Compacting Concrete

Confined Concrete-Filled Tubular Columns

Experimental research on seismic performance of confined concrete filled tubular columns under cyclic loading

Post-Earthquake Fire Resistance of Circular Concrete-Filled Steel Tubular Columns

Experimental research on seismic behavior of concrete-filled reactive powder concrete tubular columns

Experimental Study on Axial Compressive Behavior of Concrete-Filled Corrugated Steel Tubular Columns

Experimental investigation of self-compacting concrete-filled weather steel tube stub columns

08.17: Experimental Behaviour of High‐strength Thin‐walled Concrete Filled Steel Tubular Stub Columns

Experimental Performance Evaluation of Concrete-Filled Steel Tube Columns Confined by High-Strength Steel Bolts

The Study on Early-Age Expansion and Shrinkage Model of Massive Self-Compacting Concrete Pumped in Steel Tube Column

Experimental Studies On The Strength With High Slenderness Ratio Concrete Filled Steel Tubular Columns

Experimental and numerical study on self-compacting alkali-activated slag concrete-filled steel tubes

Experimental and Numerical Study on the Compression Behavior of Square Concrete-Filled Steel Tube Stub Columns with Steel Fiber-Reinforced High-Strength Concrete

Cyclic pushout tests on high‐performance concrete‐filled steel tube columns for seismic applications

Self-compacting Concrete-Filled Steel Tubes Prepared from Manufactured Sand with a High Content of Limestone Fines

Eccentric compression behaviour of rectangular concrete-filled steel tube columns with self-compacting lower expansion concrete

Experimental and numerical studies of axially loaded square concrete‐encased concrete‐filled large‐diameter steel tubular short columns

Understandings on the Performance of Concrete-Filled Steel Tube with Different Kinds of Concrete Infill

Experimental Study on Seismic Behavior of Concrete-Filled Steel Tube with Spherical-Cap Gap

Experimental Behavior of Circular Flyash-Concrete-filled Steel Tubular Stub Columns