Abstract:The stress response behaviors of steel wires at the anchorage part of bridge cables under tension and bending coupling loads play a predominant role in determining their fatigue life and failure modes. The inherent complexity of the spiral geometry and the large diameter of actual bridge cables made the stress response behaviors of steel wires at the anchorage part unclear up to now. An analytical method was proposed for spiral steel wires at the anchorage part of semiparallel steel wire cables under tension and bending coupling loads. The corresponding refined numerical modeling method was also developed for studying the local anchorage part. Both the analytical formulation and numerical model agree well with the related experimental results in the literature. The presented analytical and numerical methods are thereby efficient and accurate to simulate bridge cables under tension and bending coupling loads. The critical slip curvature of steel wires increases linearly with the tensile strain of the bridge cable. The axial stresses of the steel wires of the bridge cable at a given longitudinal location display a linear relation with the angular change at the anchorage end. For steel wires located at the guide deviator part of the bridge cable, the axial stress behavior differs between the stick and slip states. It changes to a chord curve in the longitudinal direction in the stick state, while it follows an exponential function with respect to the polar angle in the slip state. The axial stress range of the outermost steel wire of the bridge cable increases linearly with the harmonic tension load range and the bending load range, separately. Regarding the phase difference between harmonic tension and bending coupling loads, a phase difference of 0 represents the most unfavorable combination for the bridge cable. By contrast, when the phase difference falls between 0 and π/2, the two harmonic loads tend to mutually inhibit each other’s effects on the cable’s behavior.

Effect of Suspension Clamp Types on the Dynamic Bending Stress of All Aluminium Alloy 1120 Overhead Conductors

Fatigue Performance Assessment of Composite Arch Bridge Suspenders Based on Actual Vehicle Loads

Application and comparative study of the master curve methodology for predicting fatigue life in overhead conductor

Corrosion-Fatigue Analysis of Wires in Bridge Cables Considering Time-Dependent Electrochemical Corrosion Process

Fretting fatigue performance and life prediction of 1120 aluminum alloy wires of overhead conductors

Numerical and experimental analysis of fretting fatigue performance of the 1350-H19 aluminum alloy

Experimental study on dynamic bending rigidity of aluminium cable steel reinforced

Studies on the Evolution of Fatigue Strength of Aluminium Wires for Overhead Line Conductors

Investigation of sag behaviour for aluminium conductor steel reinforced considering tensile stress distribution

Effect of fatigue load on the bending tribo-corrosion-fatigue behaviors between the main cable wires

Overhead conductor heating chamber and temperature effects on the fatigue life of aluminum alloy 6201‐T81 conductors

Estimation of Overhead Transmission Lines ACSR Combined Elastic Coefficient

Experimental and finite element analysis of fatigue performance of copper power conductors

Influence Analysis of Different Compaction Degrees on the Fatigue Performance for Stranded Copper Power Conductors

Electrothermal Distortion Analysis and Structural Strain Assessment of Vehicle Cable Terminals under Bending Stresses

Stress Response Behaviors of Steel Wires at the Anchorage Part of Bridge Cables under Tension and Bending Coupling Loads

Evaluation of Strains in Dead-End Fittings of High-Temperature Low Sag Electrical Conductors Using FBG Sensors

A method for sag calculation of conductor with large section based on super long thin elastic rod model

Bending Tribo-Corrosion-fatigue Behaviors Between Cable Wire and Saddle Material in the Suspension Bridge

Electroplasticity-assisted bottom bending process

Evaluation of Flexible Central Buckles on Short Suspenders' Corrosion Fatigue Degradation on a Suspension Bridge under Traffic Load