Non-enzymatic glucose sensor using nanostructured copper oxide thin films deposited by spray pyrolysis

G. Martínez-Saucedo,M. Ugalde-Reygadas,J.J. Alcántar Peña,G. Lastra-Medina,J. Márquez-Marín,G. Torres-Delgado,R. Castanedo-Pérez,I.R. Chávez-Urbiola

DOI: https://doi.org/10.1016/j.surfin.2023.102702

IF: 6.2

2023-02-28

Surfaces and Interfaces

Abstract:Thin-film thickness effect on glucose sensitivity for a non-enzymatic sensor is affected by two main factors, film ́s conductivity, and roughness. The thin-film thickness effect is studied with copper oxide films grown by spray pyrolysis. The film is deposited with thickness in the 83 ≤ τ film ≤ 892 nm range on a nickel electrode and employed for glucose sensing in a three-electrode system as a working electrode. As the film thickness increases up to 434 nm, the signal stability and sensibility improve. For a greater thickness, the glucose sensibility starts to decrease smoothly. The sensibility increment from the thinnest film to our best condition is twofold from 0.25 to 0.47 mAmM −1 /cm 2 , and a lineal behavior is observed for a wide glucose concentration range of 0–8 mM. This work shows that a simple solution-based technique such as spray pyrolysis can be employed to obtain functional glucose sensors.

chemistry, physical,physics, applied, condensed matter,materials science, coatings & films