Abstract:Conformal cooling channels (CCCs) are widely employed in the plastic injection molding (IM) due to uniform cooling in the cooling stage. IM is a process that molten materials are pushed into the mold cavity. The cooling stage is an important part in the IM process since it takes most of the cycle time. According to practice experience, it is very difficult to improve the cycle time and quality of injection molded part simultaneously in the conventional straight drilled cooling system. Thus, improving warpage and cooling time simultaneously of the injection molded parts is a critical item in the IM. In this study, an effective method for reducing both warpage and cooling time of the wax patterns was proposed by changing the coolant temperature difference between the core and cavity inserts. It was found that both core insert with series connection CCCs and cavity insert with parallel connection CCCs is a good combination in the IM mold. The cooling efficiency of the core insert is increased from 42 to 54%, while the coolant temperature difference between the core and cavity inserts is 2 °C. The average deformation of the injection molded parts can be improved by 75.2%. The cooling time of the injection molded parts can be further reduced by 6%. The cooling time of the injection molded parts can be saved by about 30%, and the average deformation of the injection molded parts can be improved by about 60% compared with IM mold embedded with conventional cooling channel. The mechanism to minimize the amount of warpage of injection molded parts using coolant temperature difference between the core and cavity inserts is presented. Finally, the proposed method is also verified by practical implementation and comparison with experimental data. The experimental results found that the improvement rate of the average deformation of the molded parts is up to 74.5% and the cooling time of the molded parts can be reduced by approximately 15.7%. The variances compared with the simulation results are approximately 0.7% and 9.7%, respectively.

Effects of different coolant media on the cooling efficiency of aluminum-filled epoxy resin rapid tools with different surface roughness of cooling channel

Enhancing the Cooling Efficiency of Aluminum-Filled Epoxy Resin Rapid Tool by Changing Inner Surface Roughness of Cooling Channels

Characterization of rapid tooling with varying inner cooling channel surface roughness

Effects of Different Mold Materials and Coolant Media on the Cooling Performance of Epoxy-Based Injection Molds

Cooling efficiency enhancement using a rapid tool with a surface-cooled waterfall cooling channel

Effects of cooling channel layout on the cooling performance of rapid injection mold

Optimization Design of Injection Mold Conformal Cooling Channel for Improving Cooling Rate

Rapid Development of an Injection Mold with High Cooling Performance Using Molding Simulation and Rapid Tooling Technology

Thermal-Transient Analysis for Cooling Time on New Formulation of Metal Epoxy Composite (MEC) as Mold Inserts

Characterization of a direct metal printed injection mold with different conformal cooling channels

Characterizations of polymer injection molding tools with conformal cooling channels fabricated by direct and indirect rapid tooling technologies

Improving Cooling Performance of Injection Molding Tool with Conformal Cooling Channel by Adding Hybrid Fillers

A simple method of improving warpage and cooling time of injection molded parts simultaneously

Effects of cooling rates on microporosity in DC casting Al-Li alloy

The Impact of Surface Roughness on Conformal Cooling Channels for Injection Molding

A low-cost and highly efficient method of reducing coolant leakage for direct metal printed injection mold with cooling channels using optimum heat treatment process procedures

A Simple Method of Reducing Coolant Leakage for Direct Metal Printed Injection Mold with Conformal Cooling Channels Using General Process Parameters and Heat Treatment

Evaluating the Cooling Efficiency of Polymer Injection Molds by Computer Simulation Using Conformal Channels

Improving the Quality and Productivity of Molded Parts with a New Design of Conformal Cooling Channels for the Injection Molding Process

Effect of Cooling Process on Porosity in the Aluminum Alloy Automotive Wheel During Low-Pressure Die Casting

Investigation of the cooling performance of chemically etched millimeter-scale channels made by selective laser melting