Fabricating a hydrophobic modified flocculant through UVC irradiation initiation for metalworking wastewater treatment

Wei Chen,Jiujing Peng,Bin Du,Liangqian Fan,Hongbing Luo,Yanbo Lu,Keqin Feng,Huaili Zheng
DOI: https://doi.org/10.1016/j.cherd.2019.10.041
IF: 4.119
2020-01-01
Chemical Engineering Research and Design
Abstract:<p>In this work, a hydrophobically modified cationic polyacrylamide (CPAC) flocculant was polymerized by short-wave ultraviolet (UVC) initiation with acrylamide, acryloyloxyethyl trimethylammonium chloride, and coconut diethanolamide (CDEA) as monomers to enhance the destabilization and separation efficiency of emulsified oil and particles/colloids from metalworking fluids wastewater (MWFs). The parameters for flocculant polymerization were optimized, and the features of UVC-initiated polymerization were studied. Moreover, the structural and morphological characteristics of the polymers were explored, and the flocculation performance of CPAC in MWFs treatment was evaluated. The characterization results suggested that flocculants with a multilayer, loose-sheet morphology and intrinsic viscosity of 11.32 dL·g<sup>-1</sup> could be successfully polymerized by UVC-initiated polymerization. Compared with traditional UV, UVC irradiation initiation promoted the copolymerization of flocculants with a high monomer conversion rate and intrinsic viscosity. We observed the low dosage requirement and acid resistance of the flocculant synthesized by UVC-initiated polymerization, which produced the lowest residual turbidity, highest chemical oxygen demand, and most efficient oil removal during MWFs treatment among the samples studied. Besides charge neutralization and bridging effects, the adsorption effect between hydrophobic CDEA blocks and nonpolar oil/colloids facilitated the formation of microflocs and improved the flocculation efficiency of the flocculant.</p>
engineering, chemical
What problem does this paper attempt to address?