Abstract:Introduction: This study evaluated the disinfecting ability of chemomechanical preparation with rotary nickel-titanium instruments, followed by 2 distinct adjunctive procedures in the root canals of extracted mandibular molars by means of a correlative analytical approach. Methods: Twenty-two extracted mandibular molars were selected and anatomically matched between groups on the basis of micro-computed tomographic analysis. In the first phase of the experiment, root canals were contaminated with Enterococcus faecalis and subjected to chemomechanical preparation with BT RaCe instruments and 2.5% NaOCl irrigation. Then either XP-Endo Finisher instrument or passive ultrasonic irrigation was used to supplement disinfection. Micro-computed tomography was used to show whether the percentage of unprepared areas correlated to bacterial counts. In the second phase, the same teeth were contaminated once again, and the adjunctive procedures were used. Samples from the isthmus area of mesial roots and the apical 5-mm fragment of distal roots were obtained by cryopulverization. Samples taken before and after treatment steps in both phases were evaluated by quantitative polymerase chain reaction and statistically analyzed. Results: In phase 1, preparation in both groups resulted in substantial decrease of bacterial counts (P < .001). The adjunctive approaches led to a further small bacterial reduction, which was significant for XP-Endo Finisher (P < .05). No significant differences were observed between groups for persisting bacterial counts. Correlative analysis revealed no statistically significant relationship between bacterial reduction and the percentage of unprepared areas (P > .05). In phase 2, both methods had significant antibacterial effects in the main canal, but none of them could predictably disinfect the isthmus/recess areas. Conclusions: Both XP-Endo Finisher and passive ultrasonic irrigation exhibited antibacterial effectiveness, but only the former caused a significant reduction in the bacterial counts after chemomechanical preparation. None of them were effective in predictably disinfecting the isthmus/recess areas.

Effectiveness of conservative instrumentation in root canal disinfection

CT study of the performance of reciprocating and oscillatory motions in flattened root canal areas

In vitro investigation of the cleaning efficacy, shaping ability, preparation time and file deformation of continuous rotary, reciprocating rotary and manual instrumentations in primary molars

The effect of root canal preparation tapers on planktonic bacteria and biofilm reduction in the apical third: A correlative microtomography and microbiological laboratory study

Comparison of root canal transportation induced by three rotary systems with noncutting tips using computed tomography

Effect of Different Preparation Techniques on Root Canal Geometry: An In Vitro Study

Evaluation of Minimally Invasive Preparation of Curved Mesial Canals of Mandibular Molars - An In Vitro Study

The influence of different root canal open access shapes on the use of rotary root canal enlargement

Efficacy of various techniques in calcium silicate-based intracanal medicament removal: a micro-CT analysis

Adjunctive Steps for Disinfection of the Mandibular Molar Root Canal System: A Correlative Bacteriologic, Micro-Computed Tomography, and Cryopulverization Approach

Shaping Efficiency of Rotary and Reciprocating Kinematics of Engine-driven Nickel-Titanium Instruments in Moderate and Severely curved Root Canals Using Microcomputed Tomography: A Systematic Review of Ex Vivo Studies

Effects of the Irrigation Needle Design on Root Canal Disinfection and Cleaning

A Comparative Study of Antimicrobial Efficacy of Three Different Instruments and Mechanical Preparation Techniques in Single Infected Root Canals

COMPARATIVE ANALYSIS OF APICAL EXTRUSION OF DEBRIS AND SHAPING ABILITY IN CURVED ROOT CANALS USING FOUR DIFFERENT NITI INSTRUMENTS

The efficacy of ProTaper rotary NiTi and stainless hand instruments to remove gutta-percha from root canals: an ex vivo study

Shaping ability of novel nickel-titanium systems in printed primary molars

Shaping outcomes of Reciproc Blue and Rotate in roots canals with band-shaped isthmuses: micro-CT study

Influence of access cavity design on root canal instrumentation efficacy in molars - An in vitro study

Microscopic computerized tomographic evaluation of root canal transportation prepared with twisted or ground nickel-titanium rotary instruments

The Impact of Minimum Invasive Access Cavity Design on the Quality of Instrumentation of Root Canals of Maxillary Molars Using Cone-Beam Computed Tomography: An in Vitro Study

Debridement ability of the WaveOne Gold and TruNatomy systems in the apical third of root canals: ex vivo assessment