Verification of neutron-induced fission product yields evaluated by a tensor decompsition model in transport-burnup simulations

DOI: https://doi.org/10.1007/s41365-023-01176-5
2023-03-04
Nuclear Science and Techniques/Hewuli
Abstract:Neutron-induced fission is an important research object in basic science. Moreover, its product yield data are an indispensable nuclear data basis in nuclear engineering and technology. The fission yield tensor decomposition (FYTD) model has been developed and used to evaluate the independent fission product yield. In general, fission yield data are verified by the direct comparison of experimental and evaluated data. However, such direct comparison cannot reflect the impact of the evaluated data on application scenarios, such as reactor transport-burnup simulation. Therefore, this study applies the evaluated fission yield data in transport-burnup simulation to verify their accuracy and possibility of application. Herein, the evaluated yield data of and are applied in the transport-burnup simulation of a pressurized water reactor (PWR) and sodium-cooled fast reactor (SFR) for verification. During the reactor operation stage, the errors in pin-cell reactivity caused by the evaluated fission yield do not exceed 500 and 200 pcm for the PWR and SFR, respectively. The errors in decay heat and Xe and Sm concentrations during the short-term shutdown of the PWR are all less than 1%; the errors in decay heat and activity of the spent fuel of the PWR and SFR during the temporary storage stage are all less than 2 . For the PWR, the errors in important nuclide concentrations in spent fuel, such as , , , and , are all less than 6 , and a larger error of 37 is observed on . For the SFR, the concentration errors of ten important nuclides in spent fuel are all less than 16 . A comparison of various aspects reveals that the transport-burnup simulation results using the FYTD model evaluation have little difference compared with the reference results using ENDF/B-VIII.0 data. This proves that the evaluation of the FYTD model may have application value in reactor physical analysis.
What problem does this paper attempt to address?