Abstract:Neutron-induced fission is an important research object in basic science. Moreover, its product yield data are an indispensable nuclear data basis in nuclear engineering and technology. The fission yield tensor decomposition (FYTD) model has been developed and used to evaluate the independent fission product yield. In general, fission yield data are verified by the direct comparison of experimental and evaluated data. However, such direct comparison cannot reflect the impact of the evaluated data on application scenarios, such as reactor transport-burnup simulation. Therefore, this study applies the evaluated fission yield data in transport-burnup simulation to verify their accuracy and possibility of application. Herein, the evaluated yield data of and are applied in the transport-burnup simulation of a pressurized water reactor (PWR) and sodium-cooled fast reactor (SFR) for verification. During the reactor operation stage, the errors in pin-cell reactivity caused by the evaluated fission yield do not exceed 500 and 200 pcm for the PWR and SFR, respectively. The errors in decay heat and Xe and Sm concentrations during the short-term shutdown of the PWR are all less than 1%; the errors in decay heat and activity of the spent fuel of the PWR and SFR during the temporary storage stage are all less than 2 . For the PWR, the errors in important nuclide concentrations in spent fuel, such as , , , and , are all less than 6 , and a larger error of 37 is observed on . For the SFR, the concentration errors of ten important nuclides in spent fuel are all less than 16 . A comparison of various aspects reveals that the transport-burnup simulation results using the FYTD model evaluation have little difference compared with the reference results using ENDF/B-VIII.0 data. This proves that the evaluation of the FYTD model may have application value in reactor physical analysis.

Evaluation of Cumulative Yields for Short-lived Fission Products from ~(238)U(n,f)

The Dependence of Cumulative ^238u（n,f）fission Yield on Incident-Neutron Energy

Evaluation of Dependence of Cumulative Fission Yields on Incident-Neutron Energy For~(239)pu(n,f)

A New Evaluation of Fission Product Yields for the Neutron Induced Fission of U-233 and Th-232

Determination of Cross Sections for The238u(n,3n)

Energy Dependent Calculations of Fission Product, Prompt, and Delayed Neutron Yields for Neutron Induced Fission on $^{235}$U, $^{238}$U, and $^{239}$Pu

Calculation of the energy dependence of fission fragments yields and kinetic energies distributions for neutron-induced 235U fission

Nuclear data evaluation for decay heat analysis of spent nuclear fuel over 1–100 k year timescale

Evaluation of the Prompt Fission Gamma Properties for Neutron Induced Fission of 235,238U and 239Pu

Note on the potential to increase the accuracy of source term calculations for spent nuclear fuel

Calculation of Fission Fragment Yields for thermal neutron reaction of $^{239}$Pu

Evaluation of the irradiation-averaged fission yield for burnup determination in spent fuel assays

Verification of neutron-induced fission product yields evaluated by a tensor decompsition model in transport-burnup simulations

Evaluation of the Nuclear Data on (α, n) Reaction for F, Na, Al, Cr, Fe, Ni, and Cu

Fission Fragment Yields Of $^{235}$U$(n_{th},f)$ Evaluated By The CCONE Code System

Identifying and overcoming deficiencies of nuclear data on the fission of light actinides by use of the GEF code

Feedback on neutron capture cross-section of 234U from analysis of measured inventories of UO2 fuel irradiated in TMI unit 1

Semi-Empirical Study on the Yield Energy-Dependence of the 235U + N Fission

239Pu Fission Spectrum Cumulative Fission Product Yield Measurement Using Godiva IV Critical Assembly

Fission Product Yields for Thermal-Neutron Fission of Plutonium-239

Post-Neutron Mass Yield Distribution in the Epi-Cadmium Neutron-Induced Fission of 235U