Abstract:To improve the ejector refrigeration cycle performance, this paper presents a theoretical thermodynamic analysis of a novel two-stage ejector refrigeration cycle (TSERC) with a gas-liquid separator using R134a/R32 and R600a/R290 as refrigerant. By separating the relatively low-boiling-point and high-boiling-point refrigerants, the cycle compression ratio decreases, the cycle performance increases, and the energy utilization efficiency can be improved. Energy and exergy analysis were conducted for the traditional single-stage ejector refrigeration cycle (SSERC) and TSERC. The effect of the mixture mass fraction on cycle performance under a fixed external heat source operating condition was studied, and the cycle performance comparisons between TSERC and SSERC at different evaporation temperature, condensation temperature and generation temperature were conducted. Results show that for TSERC, the maximum COP values 0.126 and 0.11, the maximum exergy efficiency 4.51 % and 4 % are obtained as the low-boiling-point mass fraction equals 0.6 and 0.4 respectively for R134a/R32 and R600a/R290. It is found that exergy destruction mainly occurs in the low-pressure sub-cycle of TSERC, the top three largest exergy destruction components are ejector 1, condenser 1 and generator 1, while the smallest exergy destruction occurs in pump 2. In addition, cycle performance comparison between SSERC and TSERC shows that the maximum COP improvement increased by 41.6 % and 89.6 % for 134a/R32 and R600a/R290 for TSERC, while the maximum entrainment ratio improvement increased by 32.4 % and 87.6 %. Moreover, it is concluded that the cycle performance improvement of TSERC is more significant at lower evaporation temperature, higher condensation temperature, and lower generation temperature compared to SSERC.

Performance evaluation of a novel ejector absorption refrigeration cycle combined with two flash tanks

A Novel Ejector-Absorption Combined Refrigeration Cycle

Performance Study of an Enhanced Ejector Refrigeration Cycle with Flash Tank Economizer for Low-Grade Heat Utilization

A novel absorption refrigeration cycle

Performance evaluation and energy-saving potential comparison of a heat-powered novel compression-enhanced ejector refrigeration cycle with an economizer

Performance Analysis of a Novel Hybrid Vapor Injection Cycle with Subcooler and Flash Tank for Air-Source Heat Pumps

Theoretical Analysis on a Novel Two-Stage Compression Transcritical CO2 Dual-Evaporator Refrigeration Cycle with an Ejector

A NOVEL COMBINED EJECTOR-ABSORPTION REFRIGERATION CYCLE

Analysis of Refrigeration Cycle Performance with an Ejector

Evaluation of A Combined Ejector-Vapour-Compression Refrigeration System

Experimental Study of a New Ejector-Absorption Refrigeration Cycle Driven by Multi-Heat Sources

Energy and Exergy Analysis of a Novel Two-Stage Ejector Refrigeration Cycle Using Binary Zeotropic Mixtures{fr}analyse De L’énergie Et De L'exergie D'un Nouveau Cycle De Réfrigération À Éjecteur À Deux Étages Utilisant Des Mélanges Zéotropes Binaires

Thermodynamic Performance Evaluation of an Ejector-Enhanced Transcritical CO2 Parallel Compression Refrigeration Cycle

Performance evaluation of an ejector subcooled vapor-compression refrigeration cycle

Performance evaluation of a modified R290 dual-evaporator refrigeration cycle using two-phase ejector as expansion device

Proposal and thermodynamic analysis of an ejection-compression refrigeration cycle driven by low-grade heat

Performance Evolution on A Dual-Temperature Co2 Transcritical Refrigeration Cycle with Two Cascade Ejectors

Performance Analysis of a Modified Ejector-Enhanced Auto-Cascade Refrigeration Cycle

Thermodynamic analysis of a novel combined double ejector-absorption refrigeration system using ammonia/salt working pairs without mechanical pumps

3E analysis and multi-objective optimization of a trans-critical ejector-assisted Co2 refrigeration cycle combined with thermo-electric generator

Improvement of the wet steam ejector performance in a refrigeration cycle via changing the ejector geometry by a novel EEC (Entropy generation, Entrainment ratio, and Coefficient of performance) method