Abstract:The selective hydrogenation of acetylene has been studied over AgPd and CuPd catalysts. Controlled surface reactions were used to synthesize these bimetallic nanoparticles on both TiO2 and SiO2 supports. Chemisorption measurements of the bimetallic catalysts indicate that Pd prefers to be on the nanoparticle surface with a Cu parent catalyst, while Pd prefers to be subsurface with a Ag parent catalyst. From energy-dispersive X-ray spectroscopy analysis, the composition of the nanoparticles is determined to be more uniform on the SiO2 support compared to that on the TiO2 support. X-ray absorption spectroscopy results indicate that, after reduction, the CuPd bimetallic catalysts have some Pd–Pd bonds, but the average number of Pd–Pd bonds decreases after reaction. Infrared spectra of the adsorbed CO show that an increased fraction of isolated Pd species are present on the bimetallic catalysts compared to those on the monometallic catalysts. Adsorption of acetylene and ethylene, however, indicates adsorbed surface species that require contiguous Pd ensembles. These results suggest that the surface structure of the catalyst is highly dynamic and influenced by the gas environment, as well as the support. The catalysts are active for the selective hydrogenation of acetylene in an ethylene-rich environment under mild conditions. Over all catalysts, the ethylene selectivity is greater than 92%; however, improved selectivity is observed over the bimetallic catalysts compared to that over the monometallic Pd catalysts. An ethylene selectivity of 100% is observed over the CuPd0.08/TiO2 catalyst. The highest acetylene conversion rate per gram of Pd is observed over the CuPd0.02/TiO2 catalyst, while the highest turnover frequency is found over the AgPd0.64/TiO2 catalyst. The bimetallic SiO2-supported catalysts have lower rates than Pd/SiO2 but still show improved selectivity. The combined characterization measurements and reaction kinetics studies indicate that the performance improvements of the bimetallic catalysts may be attributed to both electronic and geometric modifications of Pd by the parent Cu or Ag metal.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acscatal.0c01536?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acscatal.0c01536</a>.UV–vis spectra during catalyst synthesis, FTIR spectra of TiO2 and SiO2 supports after reaction mixture adsorption, XANES and EXAFS spectra, and reaction time on stream data for acetylene conversion (<a class="ext-link" href="/doi/suppl/10.1021/acscatal.0c01536/suppl_file/cs0c01536_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Enhanced performance of Pd-[DBU][Cl]/AC mercury-free catalysts in acetylene hydrochlorination

Improvement of performance of a Au–Cu/AC catalyst using thiol for acetylene hydrochlorination reaction

Efficient Au-0/C Catalyst Synthesized by A New Method for Acetylene Hydrochlorination

Construction of Highly Dispersed Cu–P/Cl Active Sites Using Methyldiphenyloxophosphine for Efficient Acetylene Hydrochlorination

The Activity and Stability of PdCl 2 /C-N Catalyst for Acetylene Hydrochlorination

N-Hydroxyethyl-2-Pyrrolidone Improved Cu-Based Catalysts with High Performance for Acetylene Hydrochlorination

Deactivation of PdCl2/C catalyst in hydrochlorination of acetylene

Palladium-Based Catalysts for the Hydrochlorination of Acetylene: Reasons for Deactivation and Its Regeneration

Adsorbate-Induced Structural Evolution of Pd Catalyst for Selective Hydrogenation of Acetylene

Isolated Single-Atomic Cu Catalyst Supported on P-doped Carbon for Hydrochlorination of Acetylene

Efficient and stable N-heterocyclic ketone-Cu complex catalysts for acetylene hydrochlorination: Promotion effect of ligands revealed by DFT calculation

Deactivation of Au-Cu-K mercury-free catalyst in hydrochlorination of acetylene

Carbon-confined Cu-Pd alloy nanoparticles as high-performance catalysts for acetylene selective hydrogenation

Bimetallic Pd-K/Y-zeolite catalyst in acetylene hydrochlorination for PVC production

A Highly Active Catalyst Derived from CuO Particles for Selective Hydrogenation of Acetylene in Large Excess Ethylene

Nitrogen and phosphorus co-doped activated carbon induces high density Cu+ active center for acetylene hydrochlorination

Thermal effect optimization endows a selective and stable PdCu single atom alloy catalyst for acetylene hydrogenation

AgPd and CuPd Catalysts for Selective Hydrogenation of Acetylene

Data-Informed Discovery of High-Performance Cu-Ligand Catalysts for Acetylene Hydrochlorination

Enhancing Both Selectivity and Coking-Resistance of a Single-Atom Pd 1 /C 3 N 4 Catalyst for Acetylene Hydrogenation

Enhancing both selectivity and coking-resistance of a single-atom Pd1/C3N4 catalyst for acetylene hydrogenation