Abstract:Recent developments in multiplication circuits with fewer transistors, higher speed, and reduced energy consumption are lowering hardware costs. Approximate multiplication is used for fault-tolerant applications, such as image and signal processing. These applications offer considerable improvement at the cost of reduced accuracy. Compressors are the main component of any multiplier structure. In this work, the design of an approximate multiplier based on current mode, using 4:2 and 5:2 approximate compressors and current over scaling technique is suggested to reduce power consumption, delay, and hardware components compared to existing architectures. In the proposed approach for the design of compressor circuits, current mode binary converters with 32 nm CNTFET technology are used. This work is done in three steps: (1) converting input currents into voltage and creating multi-level voltages. (2) Implementing voltage level detector. (3) Generation of output current based on threshold voltage. The proposed technique uses less number of transistors. The simulation was done under HSPICE software and the efficiency of the compressors was compared in terms of delay, power, and power delay product (PDP). Based on the simulation results, the PDP value for 4:2 and 5:2 compressor circuits is calculated as 0.0097 and 0.0131 fJ, respectively. Then, an approximate multiplication of 8 × 8 using these compressors is designed for multiplying images under MATLAB software. This multiplier has achieved a good improvement in terms of PSNR and MSSIM (respectively 9.14 and 2.85%) compared to advanced approximate multipliers. Also, the proposed approach performs better in terms of accuracy, power consumption, and delay.

Design of a High-Speed, Low-Power PTL-CMOS Hybrid Multiplier Using Critical-Path Evaluation Model

High Quality Multiplier Design Based on Improved Circuits

Low-Power, High-Speed, and Area-Efficient Multiplier Based On the PTL Logic Style

Design of low-power and high-speed multiplier

Low-Power Pass-Transistor Logic-Based Full Adder and 8-Bit Multiplier

LMM: A Fixed-Point Linear Mapping Based Approximate Multiplier for IoT

Integrated Algorithmic Logical and Physical Design of Integer Multiplier

Implementation of High-speed Parallel Multiplier Based on Optimized Partial Product

Low Power Shift and Add Multiplier Design

An efficient design methodology for a tri-state multiplier circuit in carbon nanotube technology

8×8 Bit Pipelined Dadda Multiplier in CMOS

A Reconfigurable High-Performance Multiplier Based On Multi-Granularity Design And Parallel Acceleration

A Novel Current Mode Approximate Multiplier Scheme Based on 4:2 and 5:2 Compressors with Low Power Consumption and High Speed in CNTFET Technology

A High-Performance and Low-Cost Montgomery Modular Multiplication Based on Redundant Binary Representation

Low-Latency Online Multiplier with Reduced Activities and Minimized Interconnect for Inner Product Arrays

An Electro-Optic Mixed Structure Multiplier with an Optical Delay Accumulation Scheme in Time-Domain

Design and Implementation of a Wide-Swing CMOS Multiplier for AC Source Signal Tracking and Modulation

Power efficient design and implementation of a novel constant correction truncated multiplier

Low-Latency Scalable Modular Multiplier Without Montgomery Algorithm

Research on Electro-Optic Hybrid Multidigit Digital Multiplier Based on Surface Plasmon Polariton Technology

Simplified Carry Save Adder-Based Array Multiplier Scheme and Circuits Design