Abstract:Recent developments in multiplication circuits with fewer transistors, higher speed, and reduced energy consumption are lowering hardware costs. Approximate multiplication is used for fault-tolerant applications, such as image and signal processing. These applications offer considerable improvement at the cost of reduced accuracy. Compressors are the main component of any multiplier structure. In this work, the design of an approximate multiplier based on current mode, using 4:2 and 5:2 approximate compressors and current over scaling technique is suggested to reduce power consumption, delay, and hardware components compared to existing architectures. In the proposed approach for the design of compressor circuits, current mode binary converters with 32 nm CNTFET technology are used. This work is done in three steps: (1) converting input currents into voltage and creating multi-level voltages. (2) Implementing voltage level detector. (3) Generation of output current based on threshold voltage. The proposed technique uses less number of transistors. The simulation was done under HSPICE software and the efficiency of the compressors was compared in terms of delay, power, and power delay product (PDP). Based on the simulation results, the PDP value for 4:2 and 5:2 compressor circuits is calculated as 0.0097 and 0.0131 fJ, respectively. Then, an approximate multiplication of 8 × 8 using these compressors is designed for multiplying images under MATLAB software. This multiplier has achieved a good improvement in terms of PSNR and MSSIM (respectively 9.14 and 2.85%) compared to advanced approximate multipliers. Also, the proposed approach performs better in terms of accuracy, power consumption, and delay.

A Novel Current Mode Approximate Multiplier Scheme Based on 4:2 and 5:2 Compressors with Low Power Consumption and High Speed in CNTFET Technology

High Quality Multiplier Design Based on Improved Circuits

Comparison and design of energy-efficient approximate multiplier schemes for image processing by CNTFET

Efficient Approximate Multiplier Based on a New 1-Gate Approximate Compressor

Nonvolatile and Energy-Efficient FeFET-Based Multiplier for Energy-Harvesting Devices.

A fast and energy-efficient hybrid 4–2 compressor for multiplication in nanotechnology

A Reconfigurable Approximate Multiplier for Quantized CNN Applications.

An Optimized Compression Strategy for Compressor-Based Approximate Multiplier

A Reconfigurable Multiplier for Signed Multiplications with Asymmetric Bit-Widths.

Ultra-Fast, High-Performance 8x8 Approximate Multipliers by a New Multicolumn 3,3:2 Inexact Compressor and its Derivatives

FinFET-based Low-power Improved PDP 4:2 Approximate Compressor Design

Two Energy Efficient Unsigned Approximate Multipliers with N-4 Compressors

Image Multiplication Using Novel 4:1 Approximate Compressor*

High-speed Area-Efficient and Power-Aware Multiplier Design Using Approximate Compressors along with Bottom-Up Tree Topology

An Efficient Approximate Multiplier with Encoded Partial Products and Inexact Counter for Joint Photographic Experts Group Compression

Design of low-power and high-speed multiplier

Hardware-accuracy trade-offs for error-resilient applications using an ultra-efficient hybrid approximate multiplier

A High-Performance and Energy-Efficient Ternary Multiplier Using CNTFETs

Compressors Evolution Based High Speed and Energy Efficient Approximate Signed Multiplier

Approximate Compressor-Based Multiplier Design Methodology for Error-Resilient Digital Signal Processing

A Hardware- and Accuracy-Efficient Approximate Multiplier with Error Compensation for Neural Network and Image Processing Applications