Abstract:Energy harvesting from natural environment gives range of benefits for the Internet of things. Scavenging energy from photovoltaic (PV) cells is one of the most practical solutions in terms of power density among existing energy harvesting sources. PV power systems mandate the maximum power point tracking (MPPT) to scavenge the maximum possible solar energy. In general, a switching-mode power converter, an MPPT charger, controls the charging current to the energy storage element (a battery or equivalent), and the energy storage element provides power to the load device. The mismatch between the maximum power point (MPP) current and the load current is managed by the energy storage element. However, such architecture causes significant energy loss (typically over 20%) and a significant weight/volume and a high cost due to the cascaded power converters and the energy storage element. This paper pioneers a converter-less PV power system with the MPPT that directly supplies power to the load without the power converters or the energy storage element. The proposed system uses a nonvolatile microprocessor to enable an extremely fine-grain dynamic power management in a few hundred microseconds. This makes it possible to match the load current with the MPP current. We present detailed modeling, simulation, and optimization of the proposed energy harvesting system including the radio frequency transceiver. Experiments show that the proposed setup achieves an 87.1% of overall system efficiency during a day, 30.6% higher than the conventional MPPT methods in actual measurements, and thus a significantly higher duty cycle under a weak solar irradiance.

Fully-integrated switched-capacitor voltage boost converter with digital maximum power point tracking for low-voltage energy harvesting

A Maximum Power Point Tracking Control Scheme for PV System Based on Limit Cycle Operation

A new maximum photovoltaic power tracking control scheme based on power equilibrium at DC link

A Simple Maximum Photovoltaic Power Tracking Technique Utilizing System Inherent Limit Cycle Phenomena

A Maximum Power Point Tracking Control Scheme for PV System Based on Power Equilibrium and Its System Design

Wide-Range, High-Precision and Low-Complexity Mppt Circuit Based on Perturb and Observe Algorithm

An Analog Mppt Controller Ic Together With Its Application Circuit

An Analog Integrated MPPT Controller Designed for DMPPT Solar Array

A Low-Voltage Self-Starting Boost Converter Using MPPT with Pulse Multiplication for Energy Harvesting

An maximum power point tracking interface circuit for low-voltage DC-type energy harvesting sources

A Time-to-Voltage Converter-Based MPPT With 440 μs Online Tracking Time, 99.7% Tracking Efficiency for a Battery-Less Harvesting Front-End With Cold-Startup and Over-Voltage Protection

Photovoltaic Energy Harvesting Chip With P&O Maximum Power Point Tracking Circuit and Novel Pulse-Based Multiplier

Ultra-Low Power Boost Converter with Constant On-Time-Based Mppt for Energy Harvesting Applications

An MPPT-Based Boost Converter with Irridiance-Aware Frequency Selection and Digital ZCS Control for Solar Energy Harvesting

The MPPT Application of the FSBB Converter with MHz ZVS Digital Control

Storage-Less and Converter-Less Photovoltaic Energy Harvesting with Maximum Power Point Tracking for Internet of Things

Application of full-bridge DC/DC converter for MPPT

Dynamically Self-Adaptive Load Current Maximization Technique for Maximum Power Point Tracking in Photovoltaic Arrays

Improved solar system with maximum power point tracking

A burst-mode based boost converter harvesting photovoltaic energy for low power applications

Single-Sensor Maximum Power Point Tracking Algorithms