Abstract:For low costs, numerical simulation is an effective method to reveal the internal mechanisms inside a thermal plasma torch. Various simulation models for studying the inside or outside characteristics of thermal plasma torches have been built and discussed. However, to reveal the inside mechanisms of thermal plasma torches under various working conditions to support the materials processing, more attention should be paid to building precise models of laminar plasma torches. Thus, based on the user-defined function (UDF) and user-defined scalar (UDS) of ANSYS Fluent software, the assumptions, governing equations, boundary conditions, and solving method were discussed in detail, and a corresponding numerical model of a homemade laminar plasma torch was first built. For verifying the effectiveness of the proposed numerical model and studying the influence of the gas components on the arc characteristics, the working conditions and experimental setups were introduced in sequence. Finally, the numerical and experimental results of the homemade laminar plasma torch were obtained and discussed in detail. The study results show that: 1 The axial temperature of the plasma torch could be divided into three sections along the axis: peak temperature area (10 mm < x < 20 mm), stable temperature area (20 mm < x < 62 mm) and decrease temperature area (62 mm < x < 95 mm). Under the same input conditions, when pure argon gas was used, the peak temperature at the outlet was reached at approximately 7590 K, while for pure nitrogen and 50%Ar + 50%N2, the corresponding peak temperatures were 6785 K and 7402.2 K, respectively. 2 The axial velocity of pure nitrogen is much higher than that of pure argon and 50%Ar + 50%N2, while that of pure argon and 50%Ar + 50%N2 has little difference. In addition, when nitrogen gas was used, the peak velocity at the outlet reached 185 m/s, whereas, for argon gas and 50%Ar + 50%N2, the corresponding peak velocities were 146 m/s and 169 m/s, respectively. 3 The simulated arc voltage trends under different working conditions are well in accordance with the experimental arc voltage trends.

A novel method for predicting the occurrence of the large-scale shunting in the reverse-polarity plasma torch

A 2-D Axisymmetric Magneto-Hydrodynamic Model of a DC Arc Plasma Torch and Its Solution Methodology

Numerical Study of Plasma–Electrode Interaction During Arc Discharge in a DC Plasma Torch

Effect of Cathode-Plasma Coupling on Plasma Torch Operation Predicted by a 3D Two-Temperature Electric Arc Model

Experimental study on the life and performance of an improved DC arc plasma torch

Experimental Study of the Discharge Characteristics of a Stepped-Nozzle Arc Plasma Torch

Experimental and numerical analysis of a novel reverse-polarity plasma torch with transferred arc hot-wall nozzle for atmospheric plasma spraying of YSZ coatings

Influence of Novel Anode Structure on the Heat Flow Characteristics and Jet Stability of Pure Nitrogen Laminar Torch

Experimental study on the characteristics of V‐type arc plasma torch with four electrodes

Application of Steenbeck's minimum principle for three-dimensional modelling of DC arc plasma torches

Prediction of plasma path and analysis of axial fracturing properties in rock fragmentation by high-voltage pulsed discharge (RHPD)

Modeling and Selection of RF Thermal Plasma Hot-Wall Torch for Large-Scale Production of Nanopowders

Modeling of the Arc Characteristics inside a Thermal Laminar Plasma Torch with Different Gas Components

A Study of Arc Plasma Energy Deposition Flow Control on Blunt-Headed Protuberance Induced STBLI

Design and Study of a Large-Scale Microwave Plasma Torch with Four Ports

Design of a Stabilizing Shell for KTX

Plasma burn—mind the gap

A coupled plasma‐thermal model for hollow cathode power decomposition and parametric analysis

Three-dimensional Effects Inside a Dc Arc Plasma Torch

Three-dimensional Modelling of the Flow and Heat Transfer in a Laminar Non-Transferred Arc Plasma Torch

A discharge plasma regulation method with spike current for electrical discharge machining