Abstract:This paper conceptualizes a novel passive vibration control system comprising a tuned mass damper-inerter (TMDI) contained within a seismically isolated rooftop and investigates numerically its effectiveness for seismic response mitigation of building structures. The working principle of the proposed isolated rooftop tuned mass damper-inerter (IR-TMDI) system relies on the yielding of typical elastomeric isolators (e.g. lead rubber bearings) under severe earthquake ground motions to create a flexible rooftop which, in turn, increases the efficacy of the TMDI for seismic vibrations suppression. Herein, a nonlinear mechanical model is considered to explore the potential of IR-TMDI whereby the primary building structure is taken as linear damped single-mode system, while the Bouc–Wen model is used to capture the nonlinear/hysteretic behaviour of the rooftop isolators. An equivalent linear system (ELS), derived through statistical linearization, is used to expedite the optimal IR-TMDI tuning for different isolated rooftop properties, inertance, and primary structure natural period. To this aim, white noise excitations with different intensities as well as Kanai–Tajimi excitations for different soil conditions are considered. It is found that tuning for maximizing TMDI seismic energy dissipation is more advantageous than tuning for minimizing primary structure displacement or acceleration response since it lowers deflection and force demands to the isolators and to the inerter. Further, significant primary structure displacement and acceleration reductions are achieved as the effective rooftop flexibility increases through reduction of the nominal strength of the isolators, which verifies the intended working principle of the IR-TMDI. This is also confirmed through response history analyses to the nonlinear model under benchmark recorded ground motions. Moreover, for IR-TMDI with sufficiently flexible isolators, improved seismic structural performance with concurrent reduced deflection and force demands at the isolators is shown for all considered stochastic excitations as the inertance scales-up, which is readily achievable technologically. Thus, it is concluded that the IR-TMDI mitigates effectively structural seismic response without requiring the inerter to span several floors, as suggested in previous studies, thus extending the TMDI applicability to both existing and low-rise new-built structures.

Multi-objective optimization of the inter-story isolation system used as a structural TMD

Multi-objective optimal design of Tuned Mass Damper Inerter for base isolated structures

Damping Performance and Optimal Design of Mid-Story Isolation System with Tuned Inerter Damper

Multi-Performance Economical Optimization of Base Isolation System with Tuned Inerter Negative Stiffness Damper Subjected to Non-Stationary Seismic Excitation

Multi-objective optimal design and seismic assessment of an inerter-based hybrid control system for storage tanks

Structural control of high-rise buildings subjected to multi-hazard excitations using inerter-based vibration absorbers

An enhanced base isolation system equipped with optimal tuned mass damper inerter (TMDI)

Inerter-based tuned mass dampers for response control of multi-degree-of-freedom structures subjected to wind and earthquake excitations

Toward Optimizing Dynamic Characteristics of Non-conventional TMDs in Multi-degree-of-Freedom Systems

Simultaneous Multi-objective Optimization of Semi-active Intermediate Isolation System and Building Structure

Optimal Design of Smart Mid-Story Isolated Control System for a High-Rise Building

Design and Evaluation of Tuned Inerter-Based Dampers for the Seismic Control of MDOF Structures

Parametrized multi-objective seismic optimization for precast concrete frame with a novel post-tensioned energy dissipation beam-column joint

Multi-objective optimization and seismic performance verification of multiple tuned impact dampers for nonlinear benchmark building

Optimal Design Formula for Tuned Mass Damper Based on an Analytical Solution of Interaction between Soil and Structure with Rigid Foundation Subjected to Plane SH-Waves

Noniterative Optimization Procedure for Seismic Weakening and Damping of Inelastic Structures

Optimal TMD design for torsional balance of asymmetrical 3D structures considering soil–structure interaction

A diagram‐based design procedure for Intermediate Isolation System in existing buildings with inelastic behavior

Optimal tuned mass-damper-inerter (TMDI) design in wind-excited tall buildings for occupants’ comfort serviceability performance and energy harvesting

A novel nonlinear isolated rooftop tuned mass damper-inerter (IR-TMDI) system for seismic response mitigation of buildings

Optimum design and performance of a base-isolated structure with tuned mass negative stiffness inerter damper