Abstract:Recently, a new type of carbonate reservoir, the fault-karst carbonate reservoir has attracted lots of attention, which usually develops large-scale karst caves, vugs, and high-angle fractures along the strike-slip fault zones. Despite containing plenty of hydrocarbon resources, the complex geological structure and the strong heterogeneity make it difficult to develop this kind of reservoir effectively and economically. To perform water-drive experiments and investigate the production performance under different well patterns and injection-production modes, two 2D visualized physical models were designed and fabricated based on the typical geological structures of the fault-karst carbonate reservoir in the vertical and horizontal directions, respectively. According to the experimental results, the average oil recovery can reach 62.96% for the vertical model and 58.18% for the horizontal model. In fact, gravity effect due to density differences can greatly improve the displacement efficiency of oil by water in the vertical direction; hence, the horizontal heterogeneity would have a relatively greater impact on waterflooding development. When water is injected into the reservoir from the middle section, a large amount of un-swept oil will remain at the bottom fractures. Thus, the Bottom Injection & Top Production (BI & TP) mode should be adopted in all well patterns to increase recovery. If non-inverted well patterns are employed, dominant water channeling would form quickly in the horizontal direction, and the swept area will be hugely limited. Therefore, the Center Injection & Edge Production mode (inverted well patterns) is recommended for water-drive applications. It is also found that the water breakthrough time negatively correlates with the effective flooding time for the vertical model and the total oil recovery is more impacted by water breakthrough for both models. Additionally, the oil-water exchange ratio is introduced to evaluate the utilization efficiency of injected water. Calculation results have shown that the BI & TP mode is optimal in terms of either total recovery or oil-water exchange ratio in the vertical direction, but the well pattern layout in the horizontal direction could impact the oil recovery and oil-water exchange ratio, which, in turn, affect the project economics. This study provides novel insights for optimizing well patterns and waterflooding measures in actual fault-karst carbonate reservoirs.

Optimization Method of Three-Dimensional Equilibrium Displacement in Thin Interbed Reservoirs

An analytical solution for contaminant extraction using well injection depth extraction technology

A semi-analytical method for optimizing the gas and water bidirectional displacement in the tilted fault block reservoir

A New Method for Optimizing Water-Flooding Strategies in Multi-Layer Sandstone Reservoirs

Study on the Countermeasures and Mechanism of Balanced Utilization in Multilayer Reservoirs at Ultra-High Water Cut Period

Injection-production optimization of carbonate reservoir based on an inter-well connectivity model

Integrated Design Technology of Geological Engineering for Pressure Flooding and Water Injection in Low Permeability Reservoirs: Take the Reservoir of Keshang Formation in Wu2 East Area as an Example

Injection-production optimization of fault-karst reservoir—considering high-speed non-Darcy effect

Optimization Numerical Simulation Study on Miscible Gas Flood in Pubei Oilfield

Investigation on water-drive performance of a fault-karst carbonate reservoir under different well patterns and injection-production modes based on 2D visualized physical models

A New Methodology for Determination of Layered Injection Allocation in Highly Deviated Wells Drilled in Low-Permeability Reservoirs

Inter-well interferences and their influencing factors during water flooding in fractured-vuggy carbonate reservoirs

Physical Simulation of Gas Injection Mechanism for High Dip Reservoir

A Variable-Control Well Placement Optimization for Improved Reservoir Development

Integrated Static and Dynamic Study to Determine Optimal Infill Potential of a High Water-Cut Oilfield with Bottom Aquifer in Sudan

Experimental and Numerical Investigation on Oil Displacement Mechanism of Weak Gel in Waterflood Reservoirs

The research on high efficiency water injection development of carbonate rock reservoir in the middle east

Reservoir production optimization based on surrograte model and differential evolution algorithm

A new three-dimensional effective water-flooding unit model for potential tapping of remained oil in the reservoirs with rhythmic conditions

Optimization Study of Injection-Production Parameters for CO2 Enhanced Oil Recovery and Storage in Low Permeability Oil Reservoirs

A novel dynamic reserve evaluation method by division between oil and water in isolated fractured-caved carbonate reservoirs