Abstract:All-solid-state lithium metal batteries are projected to offer one of the highest specific energy among rechargeable batteries, positioning them as a front-runner for electric vehicle applications. Lithium metal anodes outperform conventional graphite anodes in terms of cell-level energy density. However, maintaining a conformal metal–electrolyte contact is a great challenge. The volumetric change of the lithium metal anode during stripping produces voids, which deteriorates the Li–electrolyte contact. To address this challenge, β-phase Li solid solution (i.e., Li-Mg alloy) has been shown to exhibit improved contact with the solid electrolyte during stripping. Moreover, Li solid solution has a similar electrochemical potential as Li, making it a potential replacement for Li metal anodes without sacrificing cell-level energy density. In this study, we show that the chemical properties of the alloy play an essential role in the morphological stability of metal–solid electrolyte interface. We compare the stripping behavior of pure Li and Li-Mg alloy anodes in argyrodite electrolyte and characterize the morphological evolution of the interface using operando scanning electron microscopy (SEM). We also analyze the electro-chemo-mechanical properties of Li and Li alloy anodes during stripping with galvanostatic electrochemical impedance spectroscopy (GEIS) to compare the influence of composition change and interfacial void on the electrode overpotential and interface resistance. Our research visualizes the morphological and compositional evolution of alloy metal anode during stripping and rationalizes their improved interfacial stability against solid electrolytes. Acknowledgment: This work was supported by the U.S. Department of Energy's Office of Energy Efficiency and Renewable Energy (EERE) under the Vehicle Technologies Program under Contract DE-EE0008864. Figure 1

Localized Recrystallization of a Lithium-Metal Anode during Fast Stripping in High-Activity Liquid Electrolytes

Engineering Wavy‐Nanostructured Anode Interphases with Fast Ion Transfer Kinetics: Toward Practical Li‐Metal Full Batteries

Lithium Metal Stripping Beneath the Solid Electrolyte Interphase

Failure Mechanism for Fast‐Charged Lithium Metal Batteries with Liquid Electrolytes

Operando Characterization of Plating and Stripping Dynamics of Li-Mg Alloy Anode and Sulfide Solid Electrolyte Interface

Solid-solution based metal alloy phase for highly reversible lithium metal anode.

Developing High‐Performance Lithium Metal Anode in Liquid Electrolytes: Challenges and Progress

Self-Stabilized Solid Electrolyte Interface on a Host-Free Li-Metal Anode Toward High Areal Capacity and Rate Utilization

Stable Lithium Electrodeposition in Liquid and Nanoporous Solid Electrolytes

Achieving High‐Power and Dendrite‐Free Lithium Metal Anodes Via Interfacial Ion‐Transport‐Rectifying Pump

Inward-growth plating of lithium driven by solid-solution based alloy phase for highly reversible lithium metal anode

Revealing Principles for Design of Lean-Electrolyte Lithium Metal Anode Via in Situ Spectroscopy.

A facile surface chemistry route to a stabilized lithium metal anode

Failure mechanism of lithium metal anode under practical conditions

Mechanism understanding for stripping electrochemistry of Li metal anode

(Invited) Designing New Electrolytes for High-Energy Lithium Metal Batteries

The Strategy to Tune Li Stripping/Plating Behavior in Li Alloy Anode

A Scalable Slurry Process To Fabricate A 3d Lithiophilic And Conductive Framework For A High Performance Lithium Metal Anode

Localizing Concentrated Electrolyte in Pore Geometry for Highly Reversible Aqueous Zn Metal Batteries

A mismatch electrical conductivity skeleton enables dendrite–free and high stability lithium metal anode

The Regulation of Lithium Plating Behavior by State of Stripping in Working Lithium Metal Anode