Abstract:Recently, from view-point of Global Environment, timber, i.e., one of nature-cycle materials, has been tried to be utilized as structural members of large timber buildings in Europe and North America. A representative timber of the members is Cross-laminated timber (CLT), however, CLT structural system very often restricts planning of building because of CLT being plate member. High-stiffness-strength-timber slender beam and column are significantly desired. This study focuses a hybrid glulam timber with steel deformed bar (rebar) and Epoxy resin adhesive. Aim of this study is to reveal elastic-plastic behavior of the hybrid timber column under lateral reversed cyclic loading, assumed to be attacked by a large number of big earthquakes. Column specimens were designed to yield at columnreinforced concrete foundation connection by bending. The result of loading test and its discussion are summarized as follows: (i) Proposed connection of column and foundation demonstrated potential of minimizing damage and final residualdisplacement and protecting degradation of hysteresis loop of the column even if reversed cyclic loading by 8-bigearthquakes was applied. (ii) The final residual displacement drift was minimized to be less than 1/400rad., which can be neglected by the eye ofhuman, by quasi-static cyclic reverse loadings resembled free vibration to reveal the re-centring of the column afterthe bottom flexural yielded at earthquakes. (iii) The hysteresis loops, indicated spindle shape with no pinching and abundant energy dissipation as never observedin RC columns. (iv) The column has a region near interface between column and foundation, where bending stiffness for the hybridglulam timber cannot generate, and an assumption that bending stiffness at the region is degraded as Fig. 22(b), produces fairly good estimation of lateral stiffness of the column until its yielding. (v) Lateral stiffness and loading capacity of the column produced approximately as much as those of a reinforced concretecolumn replaced wood with concrete of compressive strength 30N/mm2.

Experimental study on the compression behavior of long timber column strengthened with the novel hybrid fiber sheets

Behavior of Hybrid FRP-Concrete-Steel Tubular Columns: Experimental and Theoretical Studies

An Experimental Study of Composite Columns Filled with Eucalyptus nitens Timber under Axial Compression

Experimental Study on Seismic Retrofit and Repair of Circular Reinforcement Concrete Short Columns by Fiber Reinforced Plastic

EXPERIMENTAL STUDY ON AXIAL COMPRESSIVE BEHAVIOR OF TIMBER COLUMN LATERALLY STRENGTHENED WITH FRP

Seismic Retrofit and Repair of Circular Bridge Columns with Advanced Composite Materials

Axial Compression Behaviour of Bamboo-Wood Composite Columns Fabricated with Glubam and Laminated Veneer Lumber

Experimental Study on Timber Columns Strengthened by CFRP Subjected to Axial Compression

Calculation of axial compressive behavior of timber column laterally strengthened with FRP

Experimental and Theoretical Investigation on Shear Behaviour of Small-Scale Timber Beams Strengthened with Fiber-Reinforced Polymer Composites

Compressive behaviour of novel timber-filled steel tubular (TFST) columns

Experimental Investigation on Self-Centering Steel-Timber Hybrid Beam-Column Connections

Experimental Study on the Impact of Using FRP Sheets on the Axial Compressive Performance of Short-Circular Composite Columns

Experimental investigation on reinforced RC column with prestressed double helix FRP strip

Experimental-numerical study on axial compression performance of square concrete columns confined by new-type BFRP

Axial compressive performance of laminated bamboo column with aramid fiber reinforced polymer

BENDING ELASTO-PLASTIC BEHAVIOR OF HYBRID GLULAM TIMBER COLUMN USING STEEL BARS AND EPOXY RESIN ADHESIVE (PART 1): A LATERAL LOADING EXPERIMENT OF COLUMNS WITH RECTANGULAR SECTION

Experimental Study on Behaviour of Retrofitted Square Hollow Section Slender Columns under Axial Compression

Mechanical behavior of laminated bamboo–timber composite columns under axial compression

Composite timber-steel encased columns subjected to concentric loading