Abstract:Thermophysical experiments became a very rare phenomenon due to their expensiveness and rather complicated and time-consuming preparation and carrying out. Very often the teachers tend to prefer the computer simulation of these and those technological processes for the in-depth formation of detailed knowledge in students. The reason for such a preference is evident; this approach provides visual aspects and relatively fast attainment of the goal. A negative side of such a choice is that the future specialists are not able to judge the reliability of these and those experimental relationships between the physical parameters of the processes that are used for the machinery design. To remove this drawback of the teaching and learning process, a small-size aerodynamic tunnel was created and the detailed technique for the running of experiment and experimental data processing was elaborated. The length of the working section of this tunnel was equal to 0.5 m. The rectangular cross-section of the tunnel bore was equal to 0.35´0.15 m 2 . The heat loss was studied at the lower wall of aerodynamic tunnel that was equipped with three heating elements arranged longitudinally to the air stream. The heating elements were the strips made of konstantan with the cross-section of 10´0.11 mm 2 and the thermocouples were fixed to the lower surface. A maximum value of the local Reynolds number was Re x < 10 5 , i.e. the laminar boundary layer was actually in progress on the entire surface. When processing the obtained experimental data we took into account radiation heat losses and the heat losses caused by thermal conductivity along heating elements. Nevertheless, heat transfer intensity values turned out to be 3 to 4 times higher in comparison to those of the laminar flow mode. The numerical analysis of the thermal state of the experimental plate enabled the determination of the heat losses that were not taken into account earlier. Hence, we managed to achieve actually full coincidence of the experimental values of the intensity of heat transfer that were derived from a reliable similarity equation. The research done is required for the formation of the competence in students that study for the Master’s degree to get their specialty.

Experimental Study of the Heat Transfer at Compressible Gas Flow with a Favorable Pressure Gradient

NUMERICAL AND EXPERIMENTAL STUDY OF COMPRESSIBLE GAS FLOW THROUGH A POROUS/FLUID–COUPLED AREA

Computational and experimental evaluation of heat transfer intensity in channels of complex configuration for gas flow with different levels of turbulence

Transitional And Turbulent Convective Heat Transfer Of Compressible Gas Flows Through Microtubes

Experimental Study on the Forced Convection Heat Transfer Characteristics of Air Flow Across a Cylinder under Low Vacuum Pressures

Experimental and numerical investigations of local flow and heat transfer characteristics of partially finned flat-oval tubes

Experimental Investigation on Heat Transfer Characteristics of Smooth Tube with Downward Flow

Numerical and Experimental Simulation of Supersonic Gas Outflow into a Low-Density Medium

Heat Transfer Characteristics Of Aviation Kerosene In Vertical Upward High Flux Tubes At Supercritical Pressure

Compressibility and variable inertia effects on heat transfer in turbulent impinging jets

Convective heat transfer for incompressible laminar gas flow in micropassage with constant wall temperature

Experimental Study on Heat Transfer of Aviation Kerosene in a Vertical Upward Tube at Supercritical Pressures

Experimental Investigation of Adiabatic Gas-Liquid Flow Regimes and Pressure Drop in Slit Microchannel

Anomalous Enhancement of Vortex Heat Transfer in the Case of Separated Air Flow over an Inclined Groove in a Heated Isothermal Region of a Flat Plate

The Thermophysical Experiment Carried out for the Education of the Students Studying for the Master’s Degree to Get Heat Engineering Specialties

Effect of heat losses in the temperature transducer in measurements in hotshot wind tunnels

Heat Transfer Characteristics of Aviation Kerosene Flowing in Enhanced Tubes at Supercritical Pressure

Study of the transient gas outflow from a container

Experimental Study on the Pressure Drop and Heat Transfer Characteristics in Corrugated Tubes

Experimental Study on the Pressure Drop and Heat Transfer of Two Different Tubes With Plain-Rectangle Internal Fins

Experimental Investigation of Heat Transfer and Pressure Drop in a Two-Pass Internal Coolant Passages of Gas Turbine Airfoil