Abstract:A high-stretch positive temperature coefficient (PTC) surface heating textile (PTC-SHT) was fabricated using a composite of PTC powder and multiwall carbon nanotubes (MWCNTs). The PTC-SHT (heating area = 100 × 100 mm2) was produced by screen-printing the PTC-MWCNT composite paste onto a high-stretch textile with embroidered electrodes. Overall, the temperature increased to 56.1 °C with a power consumption of 5 W over 7 min. Subsequently, the surface temperature of the PTC-SHT remained constant despite the continued decrease in power consumption. This indicated that heating was accompanied by an increase in resistance of the PTC-SHT, which is typical of this process-i.e., heating to a constant temperature under a constant voltage over an extended period of time. In addition, 4.63 W power was required to heat the PTC-SHT surface from an external temperature of 5 to 45 °C in 10 min, after which stable low-temperature heat generation behavior was observed at a constant temperature of 50 °C, which was maintained over 40 min. In contrast, negative temperature coefficient (NTC) behavior has been observed in an NTC-SHT consisting of only MWCNTs, where a slow heating rate in the initial stage of power application and a continuous increase in surface temperature and power consumption were noted. The PTC-SHT consumed less power for heat generation than the NTC-SHT and exhibited rapid heating behavior in the initial stage of power application. The heat generation characteristics of the PTC-SHT were maintained at 95% after 100,000 cycles of 20% stretch-contraction testing, and the heating temperature remained uniformly distributed within ± 2 °C across the entire heating element. These findings demonstrated that an SHT with PTC characteristics is highly suitable for functional warm clothing applications that require low power consumption, rapid heating, stable warmth, and high durability.

Development and evaluation of cable-less heating mats utilizing low-power carbon nanotube planar heaters

A Janus Membrane Doped with Carbon Nanotubes for Wet–thermal Management

Experimental design and testing of the electrothermal properties of carbon nanotube film

Properties of Surface Heating Textile for Functional Warm Clothing Based on a Composite Heating Element with a Positive Temperature Coefficient

Stretchable, flexible fabric heater based on carbon nanotubes and water polyurethane nanocomposites by wet spinning process

Stretchable and Energy-Efficient Heating Carbon Nanotube Fiber by Designing a Hierarchically Helical Structure

Personal Thermal Management by Single-Walled Carbon Nanotubes Functionalized Polyester Fabrics

A Multifunctional Sensing and Heating Fabric Based on Carbon Nanotubes Conductive Film

Highly Stretchable and Conductive Copper Nanowire Based Fibers with Hierarchical Structure for Wearable Heaters

An Ultra-Thin Colored Textile with Simultaneous Solar and Passive Heating Abilities

Colored Woven Cloth-Based Textile for Passive Radiative Heating

High-performance electrothermal fabrics enabled by lignin-derived carbon nanotube yarns

Single-wall carbon nanotube fiber non-woven fabrics with a high electrothermal heating response

Low Power Flexible MXene-Graphene Oxide Based Heaters for Wearable Clothing

Carbon Nanotube Films with Fewer Impurities and Higher Conductivity from Aqueously Mono-Dispersed Solution via Two-Step Filtration for Electric Heating

Highly flexible, efficient, and wearable infrared radiation heating carbon fabric

Printed Nanocarbon Heaters for Stretchable Sport and Leisure Garments

Carbon nanotube-based flexible electrothermal film heaters with a high heating rate

An integrated smart heating control system based on sandwich-structural textiles

Superlow Thermal Conductivity 3D Carbon Nanotube Network for Thermoelectric Applications.

Dry and Binder-Free Deposition of Single-Walled Carbon Nanotubes on Fabrics for Thermal Regulation and Electromagnetic Interference Shielding