Abstract:Quite often, detectors for measuring nuclear performance and radiation quantities of relevance in fusion experiments are requested to withstand harsh working conditions due to intense neutron and gamma radiation fields. High temperature constitutes a further harsh element in some locations of the machine, where it is necessary to perform some on-line measurements, as expected in the breeding blanket. This is an essential component in future fusion power plants to provide tritium self-sufficiency and its performance must be continuously monitored. Some Test Blanket Modules (TBMs) will be installed in ITER to provide the first experimental data to validate the predictions on tritium production and recovery. In the meantime, within EUROfusion program, the mock-up of the Helium Cooled Pebble Bed Test Blanket Module (HCPB TBM), previously used for the TBM experiment at the Frascati Neutron Generator (FNG), had been installed at JET to test some detectors and for benchmarking numerical codes used for breeding blanket assessment during DTE2 campaign. A diamond detector, calibrated to measure the tritium production through neutron detection inside the HCPB TBM mock-up, was tested during some plasma pulses of the DTE2 campaign at JET. The main outcome is that, as far as neutron emission rate is below 10 15 s −1 , neutrons are properly detected along the plasma discharge evolution by TBM diamond detector, consistently with the JET neutron monitor KN1. Moreover, the amount of tritium measured ( E ) is 1.40 × 10 –12 tritons per source neutron and the comparison with MCNP radiation transport simulation ( C ) gives a ratio C / E = 0.77. Such measurements, considered promising, and their comparison with calculations are discussed in the present work. Criticalities emerged are analyzed and some improvements proposed with the main purpose of speeding up signal processing to make the system capable of working at higher plasma neutron emission rates.

Preliminary evaluation of NEG materials in view of CMSB replacement in HCPB TER architecture

Tritium Breeder Layer Evaluation of Fusion-Fission Hybrid System

Exploratory tritium breeding performance study on a water cooled lead ceramic breeder blanket for EU DEMO using Serpent-2

Tritium Transport Modeling and Analysis for HCCB Blanket of CFETR

Tritium transport modelling in Europe: Current status, multi-physics integration and proposal of material property data

Neutronics Analysis on High-Temperature Gas-Cooled Pebble Bed Reactors by Coupling Monte Carlo Method and Discrete Element Method

Characterization of a NEG cartridge under high pressure conditions

Technology Development for Isotope Rebalancing and Protium Removal in the EU-DEMO Fuel Cycle

Advanced modular system for tritium separation by CECE type process

Overview of tritium management in WCLL test blanket system of ITER

Measurement of tritium production in the helium cooled pebble bed test blanket module mock-up at JET during DTE2

Analysis of the integral zeolite molecular sieve process for helium CPS application

Electro-purification studies and first measurement of relative permittivity of TMBi

Preliminary thermo-mechanical assessment of the Top Cap region of the Water-Cooled Lead-Ceramic Breeder Breeding Blanket alternative concept

Minimum detectable activity concentration of online monitoring instrument in primary circuit of HTR-PM based on Monte Carlo simulation

Low-pressure THGEM-based operation with Ne+H2 Penning mixtures

Direct numerical simulations of tritium extraction in PbLi-based breeding blankets in the laminar–turbulent transition region

Feasibility Studies on the Burnup Measurement of Fuel Pebbles with Hpge Gamma Spectrometer

Performance of the improved Tritium Decanting Facility in support of JET tritium operations

Preliminary Analysis of Air Ingress Accident Mitigation Measure for HTR-PM

Source Term Study on Tritium in HTR-PM: Theoretical Calculations and Experimental Design