Abstract:With the rapid development of the semiconductor industry, fault diagnosis is an important task in routine operations to determine the root cause for faults that occur. A tool in manufacturing processes is equipped with a wide variety of sensors that record different types of process data. Wafers being processed are accompanied by a considerable amount of process data as a multivariate time series. Identifying the key process parameters and the corresponding process operations where faults occur can be used to facilitate the tasks of monitoring the process, maintaining the stability of the process, and stabilizing wafer production yield. This article proposes a novel solution procedure for fault diagnosis of wafer acceptance test (WAT) and chip probing (CP) using machine learning (ML). Based on the process flow of wafers and the corresponding process data, a sampling method, called synthetic minority oversampling technique (SMOTE), is first used to augment classification models with an imbalanced process dataset, and the best-practice SMOTE ratio is sought by using four competitive classifiers. By means of principal component analysis (PCA), the original data are transformed into visualizations to explore the distributions of good and bad lots of wafers. Based on the comparison of the four classifiers used in the test, the proposed logistic regression with data augmentation (LR-SMOTE) performs best. The ten most important features identified by using the LR are collected to determine potential failure operations. The identified failures in operations returned by using the proposed solution procedure for fault diagnosis of WAT and CP were confirmed by the engineers who work in the domain. Note to Practitioners—In semiconductor manufacturing practice, during the WAT and CP, domain engineers need to trace upstream the key process parameters and the corresponding key operations in the front-end-of-line (FEOL) process if any faults are detected in the -ack-end-of-line (BEOL) process. In fact, the FEOL and the BEOL are located in completely separate plants with different clean room standards. Bridging the information gap between these two different processes merits thorough scrutiny. Another challenge posed by fault diagnosis of WAT and CP is that the total number of features (i.e., process parameters) involved in the FEOL can be tens of thousands, leading to an adverse effect of data sparsity on model building.

Federated-Learning-based Decision Support for Industrial Internet of Things (IIoT)-based Printed Circuit Board Assembly Process

Applying data mining methodology to establish an intelligent decision system for PCBA process

Using intelligent technology and real-time feedback algorithm to improve manufacturing process in IoT semiconductor industry

Ensemble Modeling of in Situ Features for Printed Electronics Manufacturing with in Situ Process Control Potential

Detecting Manufacturing Defects in PCBs via Data-Centric Machine Learning on Solder Paste Inspection Features

The Core Industry Manufacturing Process of Electronics Assembly Based on Smart Manufacturing

A Feature Engineering-based Method for PCB Solder Paste Position Offset Prediction

Field bus-based embedded SPC system

Board-Level Functional Fault Identification Using Streaming Data

Investigating Machine Learning Techniques for Predicting the Process Characteristics of Stencil Printing

Machine-Learning Based Characteristic Estimation Method in Printed Circuit Board Production Lines

Predicting the printed circuit board cycle time of surface-mount-technology production lines using a symbiotic organism search-based support vector regression ensemble

Fault Diagnosis of Wafer Acceptance Test and Chip Probing Between Front-End-of-Line and Back-End-of-Line Processes

Deep-Learning Based Robotic Manipulation of Flexible PCBs.

Improving accuracy of automatic optical inspection with machine learning

An Efficient Defect Detection System for Printed Circuit Boards with Edge-Cloud Fusion Computing

An intelligent system for reflow oven temperature settings based on hybrid physics-machine learning model

A Smart Adaptive Production Control System (Sapcs) For Semiconductor Foundry Fab

Defect Detection in Printed Circuit Boards Using Semi-Supervised Learning

An Automated Machine Learning Approach to Inkjet Printed Component Analysis: A Step Toward Smart Additive Manufacturing