Abstract:Alumina (Al2O3) based ceramics are widely used for making machine parts, high-temperature components, wear-resistant material and biological ceramic due to their high hardness, strength, wear-resistance, and chemical and thermal stability. However, low fracture toughness (KIC∼3.0 MPa.m1/2) inhibit its usage in other potential applications where high toughness is a pre-requisite (e.g. ceramic engine). In an attempt to improve the strength, particularly the fracture toughness, two step sintering process was used. Sintering temperature was optimized based on the results obtained from dilatometer and DSC-TG analysis. X-ray fluorescence (XRF) was used to make compositional analysis of as received raw powders and X-ray Diffraction (XRD) was used to analysis the phase purity and crystallinity for both powder and sintered samples. Microstructure was investigated by using SEM. Hardness and fracture toughness was measured and its correlation with microstructure was investigated. Density was measured by Archimedes method and crystalline density from XRD. Microhardness diamond indenter was used and the diagonal length of indent and the crack lengths were measured by SEM to calculate the Vickers hardness values and fracture toughness, respectively. The maximum fracture toughness was obtained 4.03 MPa.m1/2 for Al2O3 ceramic and the hardness value was 15.97 GPa. Density was found 99.6% of the relative density of Alumina at optimum sintering cycle and the grain size was found 0.38 µm. Thermal expansion coefficient was measured by dilatometer and the calculated value was 7.9×10-6 K-1. The physical properties of the Alumina were good enough and comparable to withstand high temperature applications.

Thermal Conductivity Optimization of Porous Alumina Ceramics via Taguchi Model

Effect of Type and Content of Pore-forming Agents on Properties of Porous Alumina Membrane Support

Thermal Conductivity of Silica-aerogel (SA) and Autoclave Aerated Concrete (AAC) Composites

Enhanced mechanical properties and decreased thermal conductivity of porous alumina ceramics by optimizing pore structure

Studies on Evaluation of the Thermal Conductivity of Alumina Titania Hybrid Suspension Nanofluids for Enhanced Heat Transfer Applications

Thermal conductivity of porous alumina ceramics prepared using starch as a pore-forming agent

Structural and mechanical optimization of porous alumina structures fabricated by carbon sacrificial template

The Improved Thermal Conductivity of a Potting Material for High-Power Fast Warm-Up Cathodes

Sintering behavior of alumina rich cordierite porous ceramics

Tailoring thermal conductivity via three-dimensional porous alumina

Fabrication and Thermal Conductivity Improvement of Novel Composite Adsorbents Adding with Nanoparticles

Optimization of Thermal Conductivity of Alumina-Filled Composites by Numerical Simulations

Thermal properties of mullite based porous ceramics derived from high silica tailings obtained after extracting alumina from high alumina coal ash

Fabrication and properties of porous alumina ceramics with three different pore sizes

Influence of Phase and Morphology on Thermal Conductivity of Alumina Particle/Silicone Rubber Composites

Numerical investigations of the coupled conductive-radiative heat transfer in alumina ceramics

Optimization of sintering profile to achieve highly toughened alumina based ceramic

Effects of pore structure on thermal conductivity and strength of alumina porous ceramics using carbon black as pore-forming agent

Effect of Sintering Temperature on the Structures and Properties of Porous Aluminium Titanate Ceramics

Thermal Conductivity of Al2O3 and CeO2 Nanoparticles and Their Hybrid Based Water Nanofluids: An Experimental Study

Porous anorthite ceramics with ultra-low thermal conductivity