Abstract:The absence of seismic anisotropy in most regions of the lower mantle suggests that diffusion creep may be the dominant mechanism in the lower mantle. Because the diffusion-creep rate is inversely proportional to the 2~3 power of grain size, knowledge of the grain-growth kinetics is crucial for studying lower-mantle dynamics. For these reasons, this study determined the grain-growth kinetics of bridgmanite at a pressure of 27 GPa using advanced multi-anvil techniques.We first measured the grain sizes of bridgmanite in an olivine bulk composition with various annealing durations at 2200 K. The results were fitted to an equation dn – d0n = kt, where d and d0 are the final and initial grain sizes, respectively, n is the grain-size exponent, t is the annealing duration, and k is the growth-rate constant. This fitting yielded n = 5.2 ± 0.3, which is much smaller than given by a previous study [Yamazaki et al., 1996], n = 10.6 ± 1.1. This discrepancy may be because Yamazaki et al.’s [1996] olivine starting material may have contained adhesive water, which enhanced grain growth at the beginning of annealing. We then conducted runs at various temperatures, yielding the activation energy of 260 ± 20 kJ/mol. These results suggest that the bridgmanite grain sizes over 0.1 – 1 Gyr should have grain sizes of 150-230 μm, which is one order of magnitude larger than Yamazaki et al.’s [2006] estimation. Consequently, the lower mantle should be much harder than previously considered.Furthermore, we measured the grain-growth kinetics as a function of the fraction of coexisting ferropericlase. Although the grain-growth kinetics is almost independent of the ferropericlase fraction down to 20 vol.%, it rapidly increases with decreasing ferropericlase fraction at lower fractions. Over 0.1~4.5 Gyr, the bridgmanite grain sizes in pure-bridgmanite rock should be 2 ~ 3 orders of magnitude larger than those coexisting with 20 vol.% of ferropericlase. These results suggest that pure-bridgmanite rock has 4 ~ 9 orders of magnitude lower flow rates than pyrolite if the diffusion creep is dominant. Since the diffusion creep rate in pure-bridgmanite rock is so low, the dislocation creep should dominate in pure-bridgmanite rock. We estimated that the pure-bridgmanite rock should have 1 ~ 2.5 orders of magnitude more viscous than pyrolite if the stress condition is 0.1~0.5 MPa in the lower mantle. This variation may interpret the viscosity variation in the lower mantle inferred from the geoid analysis [Rudolph et al., 2015], subduction speed [van der Meer et al., 2018], and plume morphology [French & Romaniwicz, 2016].

Grain size sensitive creep during simulated seismic slip in nanogranular fault gouges: constraints from Transmission Kikuchi Diffraction (TKD)

Effect of grain-size evolution on the lower mantle dynamics

Grain Growth Kinetics of Bridgmanite under Topmost Lower-Mantle

Grain boundary sliding in compressed olivine aggregates.

Dislocation Creep Accommodated by Grain Boundary Sliding in Dunite

Evaluation of local stress state due to grain-boundary sliding during creep within a crystal plasticity finite element multi-scale framework

Observations of grain size sensitive power law creep of olivine aggregates over a large range of lattice‐preferred orientation strength

Flow-to-Friction Transition in Simulated Calcite Gouge: Experiments and Microphysical Modeling

Two sides of a fault: Grain-scale analysis of pore pressure control on fault slip

Strain localisation during diffusion creep: influence of grain coarsening and grain boundary sliding

Microstructural and Micromechanical Evolution of Olivine Aggregates During Transient Creep

Strain Localization in Sandstone‐Derived Fault Gouges Under Conditions Relevant to Earthquake Nucleation

Temporal and Spatial Evolution of Non-Elastic Strain Accumulation in Stanstead Granite During Brittle Creep

Effect of Low Viscosity Contrast between Quartz and Plagioclase on Creep Behavior of the Mid-Crustal Shear Zone

Mechanical Energy Dissipation During Seismic Dynamic Weakening in Calcite‐Bearing Faults

On the Mechanics of Granular Shear: the Effect of Normal Stress and Layer Thickness on Stick-Slip Properties

Intermittent Criticality Multi‐Scale Processes Leading to Large Slip Events on Rough Laboratory Faults

An Atomistic Study of Diffusion-Mediated Plasticity and Creep using Phase Field Crystal Methods

Fluid-enhanced diffusive mass transfer combined with GBS as an important process for protracted weakening in the middle-lower crust

Micro-slips inside a granular shear band as nano-earthquakes

Unstable Sliding of Plagioclase Gouge and Deformation Mechanisms Under Hydrothermal Conditions With Effective Normal Stresses of 100–300 MPa