Strain Localization in Sandstone‐Derived Fault Gouges Under Conditions Relevant to Earthquake Nucleation

Chien‐Cheng Hung,André R. Niemeijer,Ivan Vasconcelos

DOI: https://doi.org/10.1029/2024jb028889

2024-04-24

Journal of Geophysical Research Solid Earth

Abstract:Abstract Constraining strain localization and the growth of shear fabrics within brittle fault zones at sub‐seismic slip rates is important for understanding fault strength and frictional stability. We conducted direct shear experiments on simulated sandstone‐derived fault gouges at an effective normal stress of 40 MPa, a pore pressure of 15 MPa, and a temperature of 100°C. Using a passive strain marker and X‐ray Computed Tomography, we analyzed the spatial distribution of deformation in gouges deformed in the strain‐hardening, subsequent strain‐softening, and then steady‐state regimes at displacement rates of 1, 30, and 1,000 μm/s. We developed a machine‐learning‐based automatic boundary detection method to recognize the shear fabrics and quantify displacement partitioning between each fabric element. Our results show fabrics oriented along R 1 and Y (including boundary) shears are the two major fabric elements. At rates of 1 and 30 μm/s, the relative amount of displacement on R 1 shears is displacement dependent, increasing to ∼20% of the total displacement up to the strain‐softening stage, then decreasing to ∼10%–18% at the steady state. This trend is absent at the high rate where ∼18% of the displacement occurs on R 1 shears throughout all investigated stages. At all rates, the relative amount of displacement on Y shears increases linearly with displacement to a total of larger than 50% at the steady state. Our study provides constraints on the development of the active slip zone, which is an important factor controlling heating and weakening associated with small‐magnitude earthquakes with limited displacement (mm‐dm), such as induced seismicity.

geochemistry & geophysics