Abstract:Abstract. Wind data collection in the atmospheric boundary layer benefits from short-term wind speed measurements using unmanned aerial vehicles. Fixed-wing and rotary-wing devices with diverse anemometer technology have been used in the past to provide such data, but the accuracy still has the potential to be increased. A lightweight drone for carrying an industry-standard precision sonic anemometer was developed. Accuracy tests have been performed with the isolated anemometer at high tilt angles in a calibration wind tunnel, with the drone flying in a large wind tunnel and with the full system flying at different heights next to a bistatic lidar reference. The propeller-induced flow deflects the air to some extent, but this effect is compensated effectively. The data fusion shows a substantial reduction of crosstalk (factor of 13) between ground speed and wind speed. When compared with the bistatic lidar in very turbulent conditions, with a 10 s averaging interval and with the unmanned aerial vehicle (UAV) constantly circling around the measurement volume of the lidar reference, wind speed measurements have a bias between −2.0 % and 4.2 % (root-mean-square error (RMSE) of 4.3 % to 15.5 %), vertical wind speed bias is between −0.05 and 0.07 m s−1 (RMSE of 0.15 to 0.4 m s−1), elevation bias is between −1 and 0.7∘ (RMSE of 1.2 to 6.3∘), and azimuth bias is between −2.6 and 7.2∘ (RMSE of 2.6 to 8.0∘). Key requirements for good accuracy under challenging and dynamic conditions are the use of a full-size sonic anemometer, a large distance between anemometer and propellers, and a suitable algorithm for reducing the effect of propeller-induced flow. The system was finally flown in the wake of a wind turbine, successfully measuring the spatial velocity deficit and downwash distribution during forward flight, yielding results that are in very close agreement to lidar measurements and the theoretical distribution. We believe that the results presented in this paper can provide important information for designing flying systems for precise air speed measurements either for short duration at multiple locations (battery powered) or for long duration at a single location (power supplied via cable). UAVs that are able to accurately measure three-dimensional wind might be used as a cost-effective and flexible addition to measurement masts and lidar scans.

Wind speed reconstruction from three synchronized short-range WindScanner lidars in a large wind turbine inflow field campaign and the associated uncertainties

Wind field reconstruction from nacelle-mounted lidar short-range measurements

Analysis of the measurement uncertainty for a 3D wind-LiDAR

High-resolution wind speed measurements with quadcopter uncrewed aerial systems: calibration and verification in a wind tunnel with an active grid

Uncertainty Quantification for an Automatised RANS-Based Wind Resource Assessment Approach

Investigation on the Atmospheric Incoming Flow of a Utility-Scale Wind Turbine using Super-large-scale Particle Image Velocimetry

Real‐time wind field reconstruction from LiDAR measurements using a dynamic wind model and state estimation

Validation of the real-time-response ProCap measurement system for full field wake scans behind a yawed model-scale wind turbine

Inter-comparison study of wind measurement between the three-lidar-based virtual tower and four lidars using VAD techniques

Ensemble-based, large-eddy reconstruction of wind turbine inflow in a near-stationary atmospheric boundary layer through generative artificial intelligence

Blade Surface Pressure Measurements in the Field and Their Usage for Aerodynamic Model Validation

Wind turbine load validation in wakes using wind field reconstruction techniques and nacelle lidar wind retrievals

Offshore wind farm global blockage measured with scanning lidar

Towards accurate and practical drone-based wind measurements with an ultrasonic anemometer

Coastal Wind Measurements Using a Single Scanning LiDAR

Tilted lidar profiling: Development and testing of a novel scanning strategy for inhomogeneous flows

Measurement of rotor centre flow direction and turbulence in wind farm environment

Offshore wind farm cluster wakes as observed by long-range-scanning wind lidar measurements and mesoscale modeling

3D wind observations with a compact mobile lidar based on tropo- and stratospheric aerosol backscatter

Optimization of a direct detection UV wind lidar architecture for 3D wind reconstruction at high altitude

Calibration of 3-D wind measurements on a single-engine research aircraft