Abstract:Abstract. We use Doppler lidar wind profiles from six locations around the globe to evaluate the wind profile forecasts in the boundary layer generated by the operational global Integrated Forecast System (IFS) from the European Centre for Medium-range Weather Forecasts (ECMWF). The six locations selected cover a variety of surfaces with different characteristics (rural, marine, mountainous urban, and coastal urban). We first validated the Doppler lidar observations at four locations by comparison with co-located radiosonde profiles to ensure that the Doppler lidar observations were of sufficient quality. The two observation types agree well, with the mean absolute error (MAE) in wind speed almost always less than 1 m s−1. Large deviations in the wind direction were usually only seen for low wind speeds and are due to the wind direction uncertainty increasing rapidly as the wind speed tends to zero. Time–height composites of the wind evaluation with 1 h resolution were generated, and evaluation of the model winds showed that the IFS model performs best over marine and coastal locations, where the mean absolute wind vector error was usually less than 3 m s−1 at all heights within the boundary layer. Larger errors were seen in locations where the surface was more complex, especially in the wind direction. For example, in Granada, which is near a high mountain range, the IFS model failed to capture a commonly occurring mountain breeze, which is highly dependent on the sub-grid-size terrain features that are not resolved by the model. The uncertainty in the wind forecasts increased with forecast lead time, but no increase in the bias was seen. At one location, we conditionally performed the wind evaluation based on the presence or absence of a low-level jet diagnosed from the Doppler lidar observations. The model was able to reproduce the presence of the low-level jet, but the wind speed maximum was about 2 m s−1 lower than observed. This is attributed to the effective vertical resolution of the model being too coarse to create the strong gradients in wind speed observed. Our results show that Doppler lidar is a suitable instrument for evaluating the boundary layer wind profiles in atmospheric models.

Tilted lidar profiling: Development and testing of a novel scanning strategy for inhomogeneous flows

Near-Surface Wind Profiling in a Utility-Scale Onshore Wind Farm Using Scanning Doppler Lidar: Quality Control and Validation

Novel Rotor Effective Wind Speed Estimation Method for Light Detection and Ranging Application

Impact of probe volume and peak detection methods on lidar rotor effective wind speed and turbulence intensity estimations

Evaluating the Performance of Pulsed and Continuous-Wave Lidar Wind Profilers with a Controlled Motion Experiment

Wind field reconstruction from nacelle-mounted lidar short-range measurements

Evaluating wind profiles in a numerical weather prediction model with Doppler lidar

Optimization of a direct detection UV wind lidar architecture for 3D wind reconstruction at high altitude

Wind turbine load validation in wakes using wind field reconstruction techniques and nacelle lidar wind retrievals

Inter-comparison study of wind measurement between the three-lidar-based virtual tower and four lidars using VAD techniques

Estimation of the Motion-Induced Horizontal-Wind-Speed Standard Deviation in an Offshore Doppler Lidar

Experimental Evaluation of the Motion-Induced Effects for Turbulent Fluctuations Measurement on Floating Lidar Systems

Rotary-wing drone-induced flow – comparison of simulations with lidar measurements

Evaluation of tilt control for wind-turbine arrays in the atmospheric boundary layer

Aeronautics Application of Direct-Detection Doppler Wind Lidar: An Adapted Design Based on a Fringe-Imaging Michelson Interferometer as Spectral Analyzer

LiSBOA: LiDAR Statistical Barnes Objective Analysis for optimal design of LiDAR scans and retrieval of wind statistics. Part II: Applications to synthetic and real LiDAR data of wind turbine wakes

Real‐time wind field reconstruction from LiDAR measurements using a dynamic wind model and state estimation

Wind turbine wake position detection and rotor speed-based wake steering validation in a wind tunnel wake simulator

Multi-scale modeling of a wind turbine wake in complex terrain

Wind sensing with drone-mounted wind lidars: proof of concept

Wind Profiling in the Lower Atmosphere from Wind-Induced Perturbations to Multirotor UAS