Abstract:In view of the current situation where research on the dust diffusion laws of different dust source points is limited and the gap with the actual field situation is too large; this study employs an innovative gas–liquid–solid triphase coupling method to investigate how dust moves and spreads in the fully mechanized excavation face 431305 at the Liangshuijing Mine; focusing on both the dust field and the dust–fog coupled field. The results indicate that using the long-pressure short-suction ventilation method; dust movement in the roadway is primarily influenced by the airflow; which can be classified into vortex; jet; and return flow regions. The analysis reveals that different dust source points affect dust distribution patterns. Dust source 1 generates the highest dust concentration; primarily accumulating on the duct side and return air side of the roadway. By contrast; dust source 2's dust mainly gathers at the heading and the front of the cutting head. Dust sources 3 and 4 show lower dust concentrations near the top of the roadway. Dust source 5 achieves the most effective dust removal; aided by airflow and a suction fan; showcasing superior dust performance. A comprehensive comparison indicates that dust source 1 has the highest overall dust concentration. Therefore; further simulation of the distribution law of dust generated at dust source 1 under the action of water mist reveals that the dust concentration near the heading face is reduced from 2000 mg/m3 under the action of single air flow to about 1100 mg/m3. At t = 5 s; the spray droplets almost cover the entire tunneling face; leading to a significant decrease in dust concentration within 10–25 m from the tunneling face. Within 40 s; both coal dust and spray droplets are significantly reduced. The field measurement results verify the accuracy of the simulation results and provide certain guidance for promoting the sustainable development of the coal industry.

Simulation study on crucial parameters of long-compressive and short-suction ventilation in large section roadway excavation of LongWangGou coal mine

Numerical Simulation Study on the Movement Characteristics of Dust Flow in Mine Working Face

Experimental and numerical simulation study on forced ventilation and dust removal of coal mine heading surface

Numerical simulation and field test of dust control effect of exhaust ventilation in fully mechanized face

Influences of ventilation parameters on flow field and dust migration in an underground coal mine heading

Numerical Simulation Study of Gas–Liquid–Solid Triphase Coupling in Fully Mechanized Excavation Faces with Variation in Dust Source Points

Numerical analysis and control technology of gas accumulation in a large-scale specially-shaped tunnel passing through coal bearing strata

3D Simulation for Dynamic Characteristics of Airflow and Dust Control in A Laneway of Coal Mine

Effects of Air Outlet Position and Air Speed on Airflow and Dust Field Distributions

Ventilation system arrangement in large cross-section tunnels：a CFD simulation based on direct initial concentration assessment

Study of spatiotemporal evolution of coupled airflow-gas-dust multi-field diffusion at low-gas tunnel

CFD modelling of ventilation optimization for improving mine safety in longwall working faces

Optimization of structural parameters and installation position of the wall-mounted air cylinder in the fully mechanized excavation face based on CFD and orthogonal design

Numerical simulation investigation on optimal dust-exhausting airflow volume in fully mechanized caving face of high-gas coal mine

Study of dust pollution control effect based on orthogonal test and CFD numerical simulations

Ventilation characteristics of double-forced air pipe ventilation in comprehensive mechanized excavation face and determination of its optimal parameters

Distribution characteristics of an airflow–dust mixture and quantitative analysis of the dust absorption effect during tunnel sub-regional coal cutting

Study of integrated vortex ventilation and dust removal system in mechanized excavation face

Numerical study of gas–solid two-phase flow in a coal roadway after blasting

Theoretical and numerical study on critical velocity and driving force for preventing smoke backlayering in a connection roadway fire of coal mines

A Simulation Experimental Study on the Advance Support Mechanism of a Roadway Used with the Longwall Coal Mining Method