Abstract:This article introduces a small microwave remote sensing satellite weighing 310 kg, operating in low earth orbit (LEO). It is equipped with an X-band synthetic aperture radar (SAR) antenna, capable of a maximum imaging resolution of 0.6 m. To achieve the objectives of lower cost, reduced weight, minimized power consumption, and enhanced temperature stability, an optimized thermal design method tailored for satellites has been developed, with a particular focus on SAR antennas. The thermal control method of the antenna is closely integrated with structural design, simplifying the thermal design and its assembly process, reducing the resource consumption of thermal control systems. The distribution of thermal interface material (TIM) in the antenna assembly has been carefully calculated, achieving a zero-consumption thermal design for the SAR antenna. And the temperature difference of the entire antennas when powered on and powered off would not exceed 17 °C, meeting the specification requirements. In addition, to ensure the accuracy of antenna pointing, the support plate of antennas requires stable temperature. The layout of the heaters on the board has been optimized, reducing the use of heaters by 30% while ensuring that the temperature variation of the support board remains within 5 °C. Then, an on-orbit thermal simulation analysis of the satellite was conducted to refine the design and verification. Finally, the thermal test of the SAR satellite under vacuum conditions was conducted, involving operating the high-power antenna, verifying that the peak temperature of T/RM is below 29 °C, the temperature fluctuation amplitude during a single imaging task is 10 °C, and the lowest temperature point of the support plate is 16 °C. The results of the thermal simulation and test are highly consistent, verifying the correctness and effectiveness of the thermal design.

Optimal Design of Satellite Antenna Based on Sandwich Structure with a Novel Re-entrant Honeycomb Considering Thermal Load

Sensitivity Analysis of Thermal Deformation of Parabolic Antenna in Orbit

Structure design and mechanical measurement of inflatable antenna

A shape design method of large space deployable paraboloid antenna

Optimal Design and Analysis of Deployable Antenna Truss Structure Based on Dynamic Characteristics Restraints

Mesh Generation and Preventing Winding of Large Net-Shape Deployable Antennas for Satellite

A High Gain Antenna with an Optimized Metamaterial Inspired Superstrate

Multi-material optimization design for mesh reflector antennas considering space thermal effects

Design and parameter optimization of solid-surface antenna parallel mechanism constructed by multi-loop spatial coupling units

Optimization design of a novel microwave absorbing honeycomb sandwich structure filled with magnetic shear-stiffening gel

Optimization Design Method for the Cable Network of Mesh Reflector Antennas Considering Space Thermal Effects

Design of Clearance Fit Between Pico-Satellite and Its Separation Mechanism Based on Thermal-Structure Coupling

Design and analysis of 2D/3D negative hydration expansion Metamaterial driven by hydrogel

Performance Investigation Of The Flat Antenna Based On Metamaterials

Innovative design and optimization of a two-dimensional deployable nine-grid planar antenna mechanism with a flat reflection surface

A novel hybrid-honeycomb structure: Enhanced stiffness, tunable auxeticity and negative thermal expansion

A series of auxetic metamaterials with negative thermal expansion based on L -shaped microstructures

Design Optimization of Mesh Antennas for On-Orbit Thermal Effects

Thermal Optimization Design for a Small Flat-Panel Synthetic Aperture Radar Satellite

A synchronous placement and size-based multi-objective optimization method for heat dissipation design on antenna module of space solar power satellite

Optimization design method for mesh reflector antennas considering the truss deformation and thermal effects