Abstract:Composite hydrogels of polyacrylamide-graft-polyaniline possessing both good mechanical strength and excellent electrical conductivity were prepared through a two-step polymerization route. Firstly, acrylamide (Am) and N-(4-aminophenyl) acrylamide (APAm) were radically copolymerized through Co-60 gamma-irradiated initiation in aqueous solution to form P (Am-co-APAm) hydrogels, of which the aminophenyl side groups facilitated the following graft polymerization of aniline. Secondly, after the lyophilized P (Am-co-APAm) hydrogels were re-swelled in aniline aqueous solution, aniline absorbed in the macroporous hydrogels underwent the oxidation coupling graft polymerization with aminophenyl side groups of P (Am-co-APAm) to result in P(Am-co-APAm)-g-PANI composite hydrogels. As expected, the produced polyaniline was naturally deposited onto the pore wall of P (Am-co-APAm) hydrogels, leading to the formation of inter-connected conductive pathway. Fourier transfer infrared spectroscopy, combined with the repeated removal of possible homopolyaniline with N-methylpyrilidone, confirmed the successful grafting. To modulating the mechanical properties, the influences of radical polymerization parameters were investigated. By changing radiation duration and dose rate, it was found that the gel fraction (GF) of P (Am-co-APAm) hydrogels increased with the increment of irradiation dose, while swelling degree (SD) had the maximum value under medium irradiation dose,reflecting that both monomer conversion and crosslinking degree affected the GF and SD of P (Am-coAPAm) hydrogels. With the increase in monomer concentration, GF was kept going up and levelled off at 1. 5 c(o) while SD kept going down and levelled off at the same monomer concentration. The tensile strength and elongation at break of P (Am-co-APAm) hydrogels decreased, but elastic modulus increased, reflecting the cooperative impact of crosslinking degree and polymer produced. Interestingly, as observed by scanning electron microscopy,the hydrogels prepared in neutral water had the open and macro-porous morphology while those obtained in HC1 solution had no distinct pores. For both hydrogels, TEM images showed no separated polyaniline particles located in the hydrogel pores and the thickness of pore wall obviously increased, indicating the formation of continuous polyaniline layer on the previous pore wall. Therefore, after being doped with HC1, P(Am-co-APAm)-g-PANI composite hydrogels exhibited excellent conductivity as high as 7 similar to 10 S/cm, which exceeded most of the reported values for polyaniline-containing hydrogels.

Evolution of electrical conductivity in semi‐interpenetrating polymer network of shape memory polyvinyl chloride and polyaniline

Preparation of Polyaniline Doped with Acid and Polymer Using Electrochemical Deposition

Effect of Thermal Annealing on the Electrical Conductivity of Copper-Tin Polymer Composites.

Interpenetrating shape memory polyimide‐polyaniline composites with electrical conductivity

Flexible PANI/SWCNT Thermoelectric Films with Ultrahigh Electrical Conductivity.

The effect of a conductive polyaniline/carbon black composite on the performance of a semiconductive layer

Electrical Conductivity of Thermoresponsive Shape-Memory Polymer with Embedded Micron Sized Ni Powder Chains

Improving the Electrical Conductivity by Forming Ni Powder Chains in a Shape-Memory Polymer Filled with Carbon Black

Electronic Transport in Pani-Csa/Pani-Dbsa Polyblends

Wormlike Acid-Doped Polyaniline: Controllable Electrical Properties and Theoretical Investigation

Relationship Between Electrical Conductivity And Phase Morphology Of Polyaniline/polyacrylonitrile And Polyaniline/polystyrene Blends

Enhancement of Electrical Properties of Ferroelectric Polymers by Polyaniline Nanofibers with Controllable Conductivities

Interfacial polymerized copolymers of aniline and phenylenediamine with tunable magnetoresistance and negative permittivity

Effect of polyaniline content and protonating dopants on electroconductive composites

Electrically Conductive PANI-DBSA/Co-PAN Composite Fibers Prepared by Wet Spinning

Morphology and conductivity of polyaniline sub-micron fibers prepared by electrospinning

Conductive behaviour of lithium ions in polyacrylonitrile

Electrical and Structural Analysis of Conductive Polyaniline/polyacrylonitrile Composites

Preparation and Investigation of Conductive Hydrogels of Polyacrylamide-g-Polyaniline

Electrostrictive and Structural Properties of Poly(Vinylidene Fluoride-Hexafluoropropylene) Composite Nanofibers Filled with Polyaniline (Emeraldine Base)

Preparation And Electrical Properties Of Conducting Polyaniline-Polycarbonate Composite Films