Abstract:Phase change materials (PCMs) are regarded as a promising choice for thermal energy storage and thermal regulation applications owing to their extensive range of operational temperature. Nevertheless, the effective utilization of PCMs is primarily limited by their inadequate thermal conductivity. Present study investigates the efficacy of employing graphene (Gr) mono nanoparticles and graphene-silver (Gr:Ag) hybrid nanoparticles as an approach to enhance thermal features and establish a comparative analysis in energy storage performance of organic phase change material (PCM). The comparative study suggest the addition of 0.8 weight% (wt%) of hybrid Gr:Ag nanoparticles (NPs) enhanced the thermal conductivity of PCM (RT54HC) by 96 %, while 0.8 wt% addition of mono graphene NPs increases thermal conductivity by 83 %. Hybridization of Ag nanoparticle over Gr nanoparticle surface ensures uniform dispersion of nanoparticle into the PCM matrix overcoming the issue of floating in graphene mono nanoparticle and settling in silver nanoparticle. Subsequently, energy storage enthalpy of nanocomposite PCM with 0.8 wt% NPs of Gr and Gr:Ag nanoparticle results in increase in latent heat by 11 % and 8.5 % respectively. Likewise, inclusion of Gr nanoparticles resulted in a decrease in optical transmissibility by 71 %, while Gr:Ag hybrid nanoparticles led to a slightly lower decrease of 65 %. The composites also exhibited a minor alteration in their thermo-physical properties following 500 thermal cycles, thus validating the reliability of prepared nanoparticle enhanced PCMs. Further, hybrid nanocomposite applied in thermoelectric generator (TEG) that produced 425 mV in comparison to base PCM 325 mV. Therefore, the prepared nanocomposites, with their established capabilities, have the potential to make a substantial contribution to the advancement of energy storage requirements in the future.

Experimental investigation of phase change material energy storage system integrated with thermoelectric generator under transient heat loads

Experimental investigation on the influence of phase change material on the output performance of thermoelectric generator

Experimental Study on Transient Cooling Characteristics of a Realistic Thermoelectric Module under a Current Pulse Operation

Enhanced Thermal Performance of a Thermoelectric Generator with Phase Change Materials

Optimized output electricity of thermoelectric generators by matching phase change material and thermoelectric material for intermittent heat sources

Integration of thermal insulation and thermoelectric conversion embedded with phase change materials

Comprehensive Experimental Study of Thermoelectric Generators under Transient Boundary Conditions

Numerical investigation of heat transfer mechanism in an embedded PCM-TEG for better overall performance under the fluctuating heat source

Transient thermal management of temperature fluctuations during time varying workloads on portable electronics

Improving transient performance of thermoelectric generator by integrating phase change material

Research and numerical analysis on performance optimization of photovoltaic-thermoelectric system incorporated with phase change materials

Phase Change Material and the Thermoelectric Effect for Solar Energy Harvesting and Storage

Parametric study and design optimization of a thermoelectric generator system for waste heat recovery

Experimental and Numerical Investigation of the Thermal Performance of Phase-Change Module Using Built-in Electrical Heating

Thermal management analysis of new liquid cooling of a battery system based on phase change material and thermoelectric cooler

Thermal Performance and Structural Optimization of Electric Heating Module Based on KAl(SO4)212H2O/Expanded Graphite Composite Phase-Change Material

Heat transfer mechanism and structure design of phase change materials to improve thermoelectric device performance

Experimental Investigation of Thermoelectric Heat Pump-Phase Change Material Thermal Control Systems

Optimization Design and Performance Study of Wearable Thermoelectric Device Using Phase Change Material as Heat Sink

Performance Analysis of a Photovoltaic System with Thermoelectric Generator and Phase Change Material; An Experimental Approach

Organic/carbon and organic/carbon-metal composite phase change material for thermoelectric generator: Experimental evaluation