Abstract:Abstract:A 0.27 mm-thick grain-oriented silicon steel sheet with extra-low carbon was successfully produced by a novel processing route including strip casting, normalizing, two-stage cold rolling with an intermediate annealing, primary annealing, and secondary recrystallization annealing. The evolutions of microstructure and texture along the whole processing route were investigated with a special emphasis on the effects of two-stage cold rolling schedule. It was found that Goss orientation originated in the first cold rolling due to shear banding and relatively strong Goss texture evolved through the whole thickness after intermediate annealing. This is significantly different from the results in conventional process in which the origin of Goss texture is in the hot rolling stage and Goss texture only develops below the sheet surface. Besides, it was found that cold rolling schedule had significant influences on microstructure homogeneity, evolution of λ-fiber texture in primary annealed state and, thus, on secondary recrystallization. In case of appropriate cold rolling schedule, a homogeneous microstructure with Goss texture, relatively strong γ-fiber texture and medium α-fiber texture was observed in the primary annealed strip. Although Goss texture in primary annealed state was much weaker than that in two-stage route in conventional process, a perfect secondary recrystallization microstructure was produced and the magnetic induction B8 was as high as 1.85 T. By contrast, when the cold rolling schedule was inappropriate, the primary annealed strips exhibited inhomogeneous microstructure, together with weak γ-fiber texture, medium α-fiber and λ-fiber texture. Finally, the sheets showed incomplete secondary recrystallization microstructure in which a large number of fine grains still existed.

Novel Process for the Formation of Goss Grains by Concentrated Shear Strain on Surface in Inhibitor-Free Silicon Steel

Fabrication of Grain-Oriented Silicon Steel by a Novel Way: Strip Casting Process

Ultra-thin grain-oriented silicon steel sheet fabricated by a novel way: Twin-roll strip casting and two-stage cold rolling

Complete Goss Secondary Recrystallization by Control of the Grain Size and Texture of Primary Recrystallization in Grain-Oriented Silicon Steel

Development of microstructure and texture in strip casting grain oriented silicon steel

Microstructure and texture evolution of ultra-thin grain-oriented silicon steel sheet fabricated using strip casting and three-stage cold rolling method

Goss Texture Evolution in a Grain-Oriented Fe-6.5wt%Si Steel Processed by Strip-Casting

Fabrication of high-performance low silicon non-oriented electrical steels by a new method: Low-finishing-temperature hot rolling combined with batch annealing

Evolution of microstructure, texture and inhibitor along the processing route for grain-oriented electrical steels using strip casting

Research on Secondary Recrystallization Mechanism of Oriented Silicon Steel

Evolution of {0kl} 〈1 0 0〉 texture and microstructure in preparation of ultra-thin grain-oriented silicon steel

Evolution of Texture in High Permeability Grain Oriented Silicon Steel Produced by Casting Thin Slab and Rolling Process

Role of inhibitor behavior in abnormal growth of Goss grain in grain-oriented silicon steel: experiments and modeling

Technology Analysis of Producing Grain Oriented Silicon Steel by Thin Slab Casting and Rolling Process

Effects of Two-Stage Cold Rolling Schedule on Microstructure and Texture Evolution of Strip Casting Grain-Oriented Silicon Steel with Extra-Low Carbon

Effect of Gradient Heat Conduction on Secondary Recrystallization of Grain-Oriented Silicon Steel

Development of Secondary Recrystallization in high permeability grain oriented Silicon steel produced by Thin Slab Casting and Rolling process

Abnormal Grain Growth: A Potential Way to Construct Gradient Structure

Texture Evolution of the Surface Layer of High Silicon Gradient Electrical Steel and Influence on the Magnetic Properties

The origin of {113} grains and their impact on secondary recrystallization in producing ultra-thin grain-oriented electrical steel