Abstract:This paper deals with the preliminary design of bionic flapping wing vehicle. The design is driven by its requirement and objective namely the maximum weight should be less than 0.5 kg with 1.5 m wingspan. In the conceptual design, the wing planform, wing structures and system of flapping mechanism will be considered to find the initial configuration and then continued the sizing of the flapping vehicle. The analysis of designed flapping vehicle is increasingly complex due to firstly the generation of time-dependent aerodynamic forces and moments from unsteady flow around the flapping wing, secondly, flexible wing structure which generates higher thrust may cause a structure failure and thirdly, a flapping mechanism system generating differential flapping motion for the vehicle maneuver. The aerodynamic analysis for given flapping motion model is carried out using Computational Fluid Dynamics method based the solution of unsteady Reynold Averaged Navier-Stokes equations and the structure analysis is conducted with the input of aerodynamic loads using Finite Element method to find critical stresses that may cause a structure failure. As a solution of differential flapping two controlled servos are used. The architecture of electrical system is made to analysis of the distribution of data signal and power. The flight maneuver is achieved by changes in flapping frequency and sweeping angle. The selection of system components is performed by considering weight constraint. The flight maneuver is achieved by changes in flapping frequency and sweeping angle. The wing platform has elliptical shape with airfoil maximum camber of 6% chord at a quarter chord. The outer body and wing are made of foam laminated by glass fibre with the foam density of 0.045 g/cm3. The horizontal tail is made of mylar film with density of 1.38 g/cm3 and its area of 168.3 cm2. As simulated results, the amount of total lift is 4.18 Newton generated at 6 Hz flapping frequency.

Unsteady aerodynamics of flapping bionic eagle wings in forward flight: An experimental and numerical study

Design and aerodynamic characteristic analysis of unfolding-bending bionic flapping-wing aircraft

Dwarf Kingfisher-Inspired Bionic Flapping Wing and Its Aerodynamic Performance at Lowest Flight Speed

A review of bird-like flapping wing with high aspect ratio

Effects of dynamical spanwise retraction and stretch on flapping-wing forward flights

Aeroelastic characterisation of a bio-inspired flapping membrane wing

Experimental study on the effect of bionic flap parameters on airfoil aerodynamic performance

Bioinspired Morphing Wings: Mechanical Design and Wind Tunnel Experiments.

Structural design of eagle-like fluttering aircraft based on bionic principle

Aerodynamic Analysis of a Flapping Wing Aircraft for Short Landing

Research on Aerodynamic Characteristics of Bionic Flapping-wing Aircraft Based on Fluid-solid Coupling

Comparative Analysis of Improved Aerodynamic Performance: Computational Fluid Dynamics Study of the Trailing Edge Morphing Concept Parameters

Numerical study of the aerodynamic effects of bio-inspired leading-edge serrations on a heaving wing at a low Reynolds number

Aerodynamic Properties of Avian Flight as a Function of Wing Shape

Modeling, Simulation and Implementation of a Bird-Inspired Morphing Wing Aircraft

Experimental optimization of wing shape for a hummingbird-like flapping wing micro air vehicle

Aerodynamic modeling of a flexible flapping-wing micro-air vehicle in the bond graph environment with the aim of assessing the lateral control power

Overview of research status and key technologies of bionic flapping wing aircraft

Influence of bioinspired morphing on the flow field characteristics of UAV wings at low Reynolds number

Preliminary design of bionic flapping wing vehicle

A study on aerodynamics and mechanisms of elementary morphing models for flapping wing in bat forward flight