Abstract:Icing is a serious threat to the flight safety of aircraft. Lightweight and efficient electrothermal de-icing systems for carbon fiber reinforced polymer components are expected to contribute to the lightweighting and electrification of aircraft. This study presents the development and test of a novel, integrated, multifunctional composite electrothermal ice protection system. The system achieves this by incorporating a carbon-based ultra-thin flexible heating film into a carbon fiber-reinforced polymer composite laminate. T700 and M40 carbon fiber prepregs were used. The system composition and configuration were designed based on the anisotropic mechanical and thermal properties of the carbon fiber-reinforced polymer composite. The effects of ply stacking sequence, presence of insulation layer, ply angle, heating area, and prepreg type on thermal response and de-icing performance were investigated. Thermal response experiments were carried out in both room temperature and low temperature environments. A one-dimensional thermal response analysis model was developed for a representative heating structure. Comparative de-icing experiments were conducted on different samples in a low-temperature test chamber. A numerical model, based on the modified enthalpy-porosity method, was developed to simulate the de-icing process, and showed good agreement with the experimental results. Experiments and numerical calculations show that the arrangement of the heater close to the deicing surface improves the performance of the electrothermal deicing system while maintaining the overall mechanical properties of the multi-layer structure. While the insulation layer helps marginally with heat loss during de-icing, it significantly increases the system’s thermal inertia, which delays the de-icing’s start. It is recommended to minimize or eliminate insulation layer thickness. Rapid de-icing effects, combined with energy conservation, can be achieved through a short-term, high-power heating strategy.

Addressing Safety concerns in Hybrid Electric Aircrafts: In-Flight Icing Detection, Moisture Detection in Fuselage and Electrical Wiring and Interconnect System (EWIS)

Induction Heating Characteristics of Electroless Ni-Coated CFRP for Deicing and Anti-Icing

The potential for anti-icing wing and aircraft applications of mixed-wettability surfaces - A comprehensive review

Integrated Technologies for Anti-Deicing Functions and Structures of Aircraft: Current Status and Development Trends

Integrated Composite Electrothermal De-Icing System Based on Ultra-Thin Flexible Heating Film

Self-Deicing Electrolyte Hydrogel Surfaces with Pa-level Ice Adhesion and Durable Antifreezing/Antifrost Performance

Advancements in De-icing and Anti-icing Technologies used in Aircraft

Cyclic Voltammetry for Accurate Icing Detection on Simulated Aircraft Surfaces

Bio-Inspired Icephobic Coatings for Aircraft Icing Mitigation: A Critical Review

Comparative Study of Using Superhydrophobic and Icephobic Surface Coatings for Aircraft Icing Mitigation

Development of ICE/NO-ICE Sensor System for in-Flight Ice Detection

Fundamentals of Monitoring Condensation and Frost/Ice Formation in Cold Environments Using Thin-Film Surface-Acoustic-Wave Technology

Novel sandwich structural electric heating coating for anti-icing/de-icing on complex surfaces

Fabrication of an Anti-Icing Aluminum Alloy Surface by Combining Wet Etching and Laser Machining

Surface Discharges Performance of ETFE- and PTFE-Insulated Wires for Aircraft Applications

Electrical Heaters for Anti/De-Icing of Polymer Structures

Study and Validation of an Electrical Anti-Ice Integrated System for Carbon Fiber Leading Edge Airplane Wing Section

Evaluating Water Ingress in Glass Fiber Plastic/Nomex Honeycomb Panels under Varying Panel Orientation

An icephobic coating for aircraft anti-icing system

In-flight detection and identification and accommodation of aircraft icing

Hazards of In-flight Icing on Unmanned Aircraft