Abstract:Lithium–sulfur (Li–S) batteries receive great attention due to their high theoretical energy density and low cost. However, the sulfur–carbon cathode suffers from the polysulfide dissolution during cycling, and the severe shuttle effect limits the practical application of Li–S batteries. In this work, a carbon material (XU76 carbon) derived from industry-residual petroleum was synthesized with a simple and low-cost method. Nitrogen adsorption, small-angle neutron scattering (SANS), adsorption kinetics, and UV–vis spectroscopy results show that the interconnected micromesopores in XU76 could act as a reservoir and trap polysulfide intermediates efficiently. The XU76 carbon with high surface area (∼1005 m2 g–1), good electric conductivity, good ion transport, and optimized distribution of interconnected micromesopores is used as the sulfur host for trapping polysulfide intermediates and advancing sulfur redox kinetics. The Li–S battery with the sulfur–XU76 carbon cathode gives an initial discharge capacity of ∼1200 mAh g–1 in the initial cycle and reversible capacity of ∼700 mAh g–1 after 100 cycles at a C rate of 0.1 C while the Li–S battery with the sulfur–KB carbon cathode only delivers a discharge capacity of 400 mAh g–1 after 100 cycles. Also, a discharge capacity of 462 mAh g–1 is obtained after 200 cycles at a high C rate (1 C). The detailed reaction mechanism of sulfur–carbon cathodes is systematically studied at high C rates using operando Raman and S K-edge X-ray absorption spectroscopy.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acssuschemeng.1c08196.Cell configuration of operando XAS measurements (Figure S1), cell configuration of operando Raman measurements (Figure S2), SEM images of KB and XU76 carbon (Figure S3), XRD results of KB and XU76 carbon (Figure S4), electrochemical performance of the sulfur–carbon cathode in Li–S batteries (Table S1), EIS plots of the sulfur–KB cathode and sulfur–XU76 cathode (Figure S5), experimental UV–vis absorption bands and assignments for the sulfur species (Table S2), operando Raman spectra of the sulfur–XU76 cathode and sulfur–KB cathode (Figure S6), and operando XRD results of the sulfur–XU76 cathode (Figure S7) (PDF)This article has not yet been cited by other publications.

Biomass-Derived Carbon for High-Performance Lithium-Sulfur Batteries

A Nitrogen/Oxygen Dual-Doped Porous Carbon with High Catalytic Conversion Ability Toward Polysulfides for Advanced Lithium–Sulfur Batteries

Bio-derived N-doped Porous Carbon As Sulfur Hosts for High Performance Lithium Sulfur Batteries

Surface-coated AlF3 Nanolayers Enable Polysulfide Confinement Within Biomass-Derived Nitrogen-Doped Hierarchical Porous Carbon Microspheres for Improved Lithium-Sulfur Batteries

Bimetallic Nanoparticles Decorated Porous Carbon As the Host Material to Enhance the Performance of Lithium-Sulfur Batteries

Facile and Scalable Synthesis of Micro-Mesoporous Carbon/magnesium Oxide/sulfur Composite for Lithium-Sulfur Batteries

Porous Coconut Shell Carbon Offering High Retention and Deep Lithiation of Sulfur for Lithium-Sulfur Batteries

Green Production of Biomass-Derived Carbon Materials for High-Performance Lithium–Sulfur Batteries

Sustainable “Sweet and Salty” Synthesis of Hierarchical Porous Carbon for Lithium–Sulfur Batteries

Built‐in Carbon Nanotube Network Inside a Biomass‐Derived Hierarchically Porous Carbon to Enhance the Performance of the Sulfur Cathode in a Li‐S Battery

Atomic-Layer-Deposition Functionalized Carbonized Mesoporous Wood Fiber for High Sulfur Loading Lithium Sulfur Batteries

Green biomass-derived hierarchically porous non-activated carbon from carob waste for high-performance lithium-sulfur batteries

Porous Carbon Hosts For Lithium-Sulfur Batteries

High specific surface area bimodal porous carbon derived from biomass reed flowers for high performance lithium-sulfur batteries

Ordered Mesoporous Graphitic Carbon/Iron Carbide Composites with High Porosity As a Sulfur Host for Li-S Batteries.

Interconnected Microporous and Mesoporous Carbon Derived from Pitch for Lithium–Sulfur Batteries

Encapsulating Sulfur into a Gel-Derived Nitrogen-Doped Mesoporous and Microporous Carbon Sponge for High-Performance Lithium-Sulfur Batteries

Optimized Sulfur-Loading in Nitrogen-Doped Porous Carbon for High-Capacity Cathode of Lithium–sulfur Batteries

Multifunction-balanced porous carbon and its application in sulfur-loading host and separator modification for lithium–sulfur batteries

Chitosan-derived N-doped Porous Carbon with Fiber Network Structure for Advanced Lithium‑sulfur Batteries

Nitrogen and oxygen co-doped porous biocarbon@sulfur/carbon nanotubes as cathodes for high-performance lithium-sulfur batteries