Abstract:Background Dual‐energy (DE) detection of bone marrow edema (BME) would be a valuable new diagnostic capability for the emerging orthopedic cone‐beam computed tomography (CBCT) systems. However, this imaging task is inherently challenging because of the narrow energy separation between water (edematous fluid) and fat (health yellow marrow), requiring precise artifact correction and dedicated material decomposition approaches. Purpose We investigate the feasibility of BME assessment using kV‐switching DE CBCT with a comprehensive CBCT artifact correction framework and a two‐stage projection‐ and image‐domain three‐material decomposition algorithm. Methods DE CBCT projections of quantitative BME phantoms (water containers 100–165 mm in size with inserts presenting various degrees of edema) and an animal cadaver model of BME were acquired on a CBCT test bench emulating the standard wrist imaging configuration of a Multitom Rax twin robotic x‐ray system. The slow kV‐switching scan protocol involved a 60 kV low energy (LE) beam and a 120 kV high energy (HE) beam switched every 0.5° over a 200° angular span. The DE CBCT data preprocessing and artifact correction framework consisted of (i) projection interpolation onto matched LE and HE projections views, (ii) lag and glare deconvolutions, and (iii) efficient Monte Carlo (MC)‐based scatter correction. Virtual non‐calcium (VNCa) images for BME detection were then generated by projection‐domain decomposition into an Aluminium (Al) and polyethylene basis set (to remove beam hardening) followed by three‐material image‐domain decomposition into water, Ca, and fat. Feasibility of BME detection was quantified in terms of VNCa image contrast and receiver operating characteristic (ROC) curves. Robustness to object size, position in the field of view (FOV) and beam collimation (varied 20–160 mm) was investigated. Results The MC‐based scatter correction delivered > 69% reduction of cupping artifacts for moderate to wide collimations (> 80 mm beam width), which was essential to achieve accurate DE material decomposition. In a forearm‐sized object, a 20% increase in water concentration (edema) of a trabecular bone‐mimicking mixture presented as ∼15 HU VNCa contrast using 80–160 mm beam collimations. The variability with respect to object position in the FOV was modest ( 0.9. A femur‐sized object presented a somewhat more challenging task, resulting in increased sensitivity to object positioning at 160 mm collimation. In animal cadaver specimens, areas of VNCa enhancement consistent with BME were observed in DE CBCT images in regions of MRI‐confirmed edema. Conclusion Our results indicate that the proposed artifact correction and material decomposition pipeline can overcome the challenges of scatter and limited spectral separation to achieve relatively accurate and sensitive BME detection in DE CBCT. This study provides an important baseline for clinical translation of musculoskeletal DE CBCT to quantitative, point‐of‐care bone health assessment.

Quantification of bone marrow edema using dual-energy CT at fracture sites in trauma

Dual-energy CT: Impact of detecting bone marrow oedema in occult trauma in the Emergency

Dual-energy CT in musculoskeletal trauma

Quantitative Dual-Energy Imaging of Bone Marrow Edema Using Multisource Cone-Beam CT with Model-Based Decomposition

Dual-energy CT in sacral fragility fractures: defining a cut-off Hounsfield unit value for the presence of traumatic bone marrow edema in patients with osteoporosis

Diagnostic accuracy of dual energy CT in the assessment of traumatic bone marrow edema of lower limb and its correlation with MRI

Extent of bone marrow edema on dual-energy CT aids in differentiation of acute from post-acute fractures of lower legs

Feasibility of bone marrow edema detection using dual‐energy cone‐beam computed tomography

Diagnostic accuracy of dual-energy CT for detecting bone marrow edema in patients with acute knee injuries: a systematic review and meta-analysis

Dual energy computed tomography evaluation of skeletal traumas

Diagnostic accuracy of dual-energy CT for bone marrow edema in patients with acute knee injury: a systematic review and meta-analysis

Diagnostic performance of dual-energy CT in detecting bone marrow edema in lower limb joint injuries: a meta-analysis

Preliminary evaluation of dual-energy CT to quantitatively assess bone marrow edema in patients with diabetic foot ulcers and suspected osteomyelitis

Diagnostic accuracy of dual-energy CT for the detection of bone marrow edema in the appendicular skeleton: a systematic review and meta-analysis

Diagnostic Accuracy of Dual-Energy CT Material Decomposition Technique for Assessing Bone Status Compared with Quantitative Computed Tomography

Dual-Energy CT and Cinematic Rendering to Improve Assessment of Pelvic Fracture Instability.

Diagnostic Accuracy of Dual-Energy CT for Bone Stress Injury of the Lower Limb.

Dual-Energy Computed Tomography and Beyond: Musculoskeletal System

Dual-Energy CT: A Promising New Technique for Assessment of the Musculoskeletal System

Dual‐energy CT for occult pelvic fractures: An audit and roc analysis

Accuracy and precision of volumetric bone mineral density assessment using dual-source dual-energy versus quantitative CT: a phantom study